Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Fulterer 5014 is a 34 inch over-travel side-mount ball bearing drawer slide rated 225 lb per pair, finished in zinc, with a hold-in detent that keeps the drawer shut until pulled. Designed for heavy storage drawers, shop benches, and worktop applications where the load exceeds the standard cabinet class and the drawer needs to clear an overhang or deep face frame at full open.
At 225 lb per pair, the 5014 is in a different class than the 100 lb slides used in kitchen cabinetry. It suits shop benches loaded with tools, utility drawers under commercial worktops, and storage drawers in garage or industrial cabinets where a standard cabinet slide would be undersized. The over-travel means the drawer does not just reach the cabinet face at full open — it goes past it, so contents near the back are reachable even when the drawer sits under a counter overhang or behind a thick face frame. The hold-in detent is a practical addition in any work environment: a loaded drawer pushed shut stays shut instead of bouncing back into the aisle.
The slide is cold-formed steel throughout, with a zinc electroplate finish. Zinc is the working standard for heavy-duty side-mount slides: functional, durable, and suited to indoor service in shops, utility rooms, and commercial cabinetry. It is not a decorative or stainless finish, and this slide is intended for dry indoor applications. The 34 inch length requires 3/4 inch of side clearance per side — note that this is wider than the 1/2 inch clearance common on standard cabinet slides, so the drawer box must be sized accordingly.
Cabinet shops building shop furniture, contractors fitting heavy utility storage, and designers specifying commercial casework will find the 5014 sized where standard slides leave off. The 225 lb rating handles densely loaded drawers, the over-travel earns its keep in any install with a countertop overhang, and the non-handed design means one SKU covers both sides of every drawer. Because this is a standard-motion slide with a hold-in detent, there is no closing mechanism to wear out or adjust — the drawer rides the bearings and stays where it is put.
Per pair. Both slides together carry 225 lb — do not double that number by counting each slide separately.
No. The 5014 is a standard-motion slide with a hold-in anti-rebound detent. The detent keeps the drawer closed but does not slow or dampen the closing action — the drawer stays where it is pushed, it does not close itself.
The heavier-duty profile of the 5014 is wider than a standard cabinet slide. Build the drawer box 1-1/2 inches narrower than the cabinet opening to leave the required 3/4 inch of clearance on each side.
Past the 34 inch slide length. Over-travel means the drawer member extends beyond the nominal length of the slide, carrying the drawer clear of any countertop overhang at full open. The exact over-travel distance is not specified in the source data.
No. The 5014 is non-handed — the same slide fits either side of the drawer. Order the pair count your project requires.
The slide mounts to the side of the cabinet interior. In face-frame construction the slide needs rear support — use series-matched rear mounting brackets, sold separately, to carry the back end of the slide where the cabinet side is set back from the face frame.
When the drawer is heavy, the workspace is tight, and the job demands a slide that stays put, the Fulterer 5014 in zinc delivers the capacity, the over-travel, and the hold-in detent in a single non-handed pair.
Sold In: 4 Set
