Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 30 inch over-travel side-mount ball bearing drawer slide from Fulterer, rated 225 lb per pair, with a hold-in detent that keeps the drawer closed and over-travel action that carries the drawer past the cabinet face. Zinc finish, non-handed, and built for drawers that carry real weight under worktops or behind deep face frames.
A 30 inch slide at 225 lb per pair is not a kitchen cabinet slide — it is the right tool for shop drawers loaded with tools, heavy utility storage under a workbench, and any drawer sitting beneath a countertop overhang where plain full extension still leaves you short. Over-travel carries the drawer member beyond the slide's nominal length, so the full contents of a deep drawer are reachable even when a few inches of overhang stand in the way. The hold-in detent adds an important detail for loaded drawers: when you push a 200-plus-pound drawer shut, it stays shut and does not rebound. No soft-close, no spring assist — just a solid mechanical catch that holds until pulled.
The slide is cold-formed steel with a zinc electroplate finish. Zinc is the working standard for heavy-duty side-mount ball bearing slides — it handles the mechanical demands of a high-load, high-cycle drawer without adding unnecessary cost. The finish is functional, not decorative: it protects the steel through years of indoor service in a shop, cabinet room, or utility space. Because the slide sits beside the open drawer rather than beneath it, the zinc finish stays mostly out of sight in everyday use. This product requires 3/4 inch of side clearance per side — build the drawer box accordingly.
Cabinet shops installing heavy base storage, contractors fitting tool drawers into workbenches, and anyone building under a countertop overhang where the drawer needs to clear the face completely will find this slide sized for the job. The 225 lb per pair rating covers drawers loaded with hardware, heavy tools, or dense shop stock. The non-handed design matters in volume installs: one SKU covers both sides of every drawer, cutting ordering complexity in half. This is a standard-motion slide — no self-close, no soft-close — which keeps the mechanism simple and lets the hold-in detent do its job without interference.
Over-travel is still useful without an overhang — it brings the drawer slightly further past the cabinet face, making the rear contents easier to reach. But if a flush installation is your priority, confirm the extra travel clears any frame or trim before ordering.
30 inches is the closed length of the slide. Travel is a separate spec: this slide is over-travel, meaning the drawer member extends beyond 30 inches. The exact over-travel distance is not stated in the available data; contact the product team to confirm before building the drawer box.
A mechanical catch engages when the drawer is pushed closed and holds it there until intentionally pulled open. It prevents a heavy, loaded drawer from bouncing back open after a firm close. It is not a lock, not a soft-close damper, and not a spring that pulls the drawer shut — it simply holds the position.
No. The slide is non-handed, so the same part fits either side of the drawer. Order the quantity your drawer count requires.
Side-mount slides in face-frame cabinets need support at the rear of the slide — typically a rear mounting bracket — because the cabinet side is set back from the face frame. Rear mounting brackets for this series are sold separately; confirm the correct bracket for the Fulterer 5012 before installing in face-frame construction.
When the load is heavy, the space is tight, and the drawer has to stay closed between uses, the combination of 225 lb capacity, over-travel extension, and a hold-in detent gives you the slide matched to that specific set of demands — in a zinc-finished, non-handed package that simplifies every installation.
Sold In: 4 Set
