#5 x 14.5mm Flat Head Euro Screw, Pozi Drive Euro Thread and Blunt Point, Nickel, Box of 10000 by Wurth

14.5 mm Euro Screw For Slightly Deeper Panel Stock and Full Hardware Engagement

This Würth #5 x 14.5 mm flat head euro screw is designed for mounting European cup hinges, drawer slides, and other 32 mm system hardware to cabinet panels where a 14.5 mm length provides secure thread engagement without over-penetrating the substrate. Packed 10,000 to the box, it is sized for cabinet shops and installers who need consistent hardware performance across high-volume production runs.

Key Features

• 14.5 mm length seats fully into the line-bore hole while leaving adequate material behind the panel face for solid holding power.
• #5 gauge with 7.2 mm flat head matches the countersink geometry of standard European hardware mounting plates for a flush, clean seat.
• Euro thread with blunt point is engineered for pre-bored 5 mm line-bore holes — threads engage cleanly without self-starting into unprepared material.
• Pozidriv #2 drive resists cam-out during power driving, keeping the bit engaged through repeated installations on a production line.
• Nickel finish blends with the hardware and interior cabinet surfaces common in kitchen and bath cabinetry.
• Confirmed compatibility with Blum hardware so the screw seats correctly in Blum hinge plates and drawer slide mounting brackets.

Where 14.5 mm Length Makes the Difference

Euro screws come in a range of lengths because panel thickness and hardware stack-up vary across cabinet lines. At 14.5 mm, this screw reaches deeper into the panel than a 10 mm or 11.5 mm option while stopping short of the 20 mm length used in thicker or double-layer substrates. That makes it well suited for standard 3/4-inch (19 mm) cabinet panels where the hardware plate adds a small amount of stand-off and the screw needs to reach into solid material behind the bore. It also works in situations where a manufacturer's installation spec calls for a longer engagement length than the shortest euro screws provide — common with certain Blum hinge plates and undermount slide brackets that seat against a washer face rather than flush to the panel.

Euro Thread, Blunt Point, and Nickel Finish

The euro thread on this screw is matched to the 5 mm pre-bored holes of a 32 mm system cabinet. The blunt point requires that hole to already be present — this is not a self-starting wood screw. That design keeps the thread engagement precise and prevents the screw from wandering or splitting material during installation. The 7.2 mm flat head seats into the countersink geometry of standard European hardware mounting plates, leaving a flush surface that does not interfere with hinge cup function or slide travel. The nickel finish coordinates with the hardware finishes most commonly found in frameless kitchen and bath cabinetry, so the fastener does not stand out against the surrounding components.

Production Cabinet Shops and High-Volume Installers

A box of 10,000 screws is sized for shops running cabinet lines rather than for one-off repairs. Euro screws are consumed in volume — a single kitchen can require dozens of hinges and slides, each needing multiple screws — so keeping a full box on the bench reduces mid-job stock-outs. The Pozidriv drive holds up well in automated and semi-automated screwdriving because the parallel flank geometry resists the cam-out that wears down Phillips bits during repetitive driving cycles. Installers setting Blum hardware in the field benefit from the confirmed compatibility, which removes uncertainty about whether the screw head will seat correctly in the plate or require adjustment.

Common Questions

The Right Length, Ready in Quantity

When 14.5 mm is the specified length for your hardware installation, this Würth euro screw delivers the thread engagement, head geometry, and drive performance needed to keep a production line moving without interruption.