Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rev-A-Shelf 4WCTM waste pullout puts two covered trash bins behind a base cabinet door in a maple-finished hardwood carriage, sized for a wider face-frame opening and rolling out on full-extension slides for complete access to both bins.
Two 35 quart bins give this pullout enough combined volume to handle a busy kitchen: one bin for general waste and one for recycling, both behind the same door. Because the carriage runs on full-extension slides, both bins come out completely when the pullout is opened, so there is no awkward reaching to the rear bin. The top-mount configuration means the bins hang from the carriage rather than resting on the cabinet floor, which simplifies cleanup below and makes each bin easy to lift straight out when it is time to empty it.
The carriage is built from maple hardwood with a natural maple finish, a practical match for kitchen cabinets built in maple or finished in similar light wood tones. The two white bins sit cleanly in the carriage and lift out independently. Standard full-extension slides handle the load rating of 150 pounds, which is solid capacity for two bins running close to full. For kitchens where soft-close motion matters, the 4WCTM series also offers soft-close slide configurations in other SKUs.
This pullout is built for face-frame cabinet construction and needs a minimum opening of 20-3/4 inches wide, 22-3/4 inches deep, and 18-11/32 inches tall. That wider opening puts it in the category of a full-size base cabinet bay, not a narrow sink-base run. It fits kitchens where a wider cabinet is dedicated to waste management, or anywhere a two-bin pullout is the organizing centerpiece of the base run. Cabinet shops specifying for a production kitchen build will find the maple carriage a natural fit for maple-box cabinet lines. Homeowners renovating a kitchen with face-frame cabinetry and an open 21-inch bay can drop this unit in as a straightforward replacement or new install.
This unit requires a minimum opening of 20-3/4 inches wide, 22-3/4 inches deep, and 18-11/32 inches tall in a face-frame cabinet. Measure all three before ordering.
Two 35 quart white bins are included with the carriage. Check the specific SKU listing to confirm lid inclusion, as lids are offered separately in some configurations of this series.
No. This pullout is built and sized for face-frame cabinet construction. For frameless cabinets, look for the frameless-specific variants in the 4WCTM series.
The carriage is door-mount ready, but the door-mount kit is sold separately. Add the appropriate Rev-A-Shelf door-mount hardware for this series to have the pullout travel with the door.
Choose this pullout to put a full trash-and-recycling setup behind a single wide face-frame cabinet door, with a maple carriage that finishes cleanly and full-extension slides that bring both bins all the way out.
Sold In: 1 Each
