Titanium Concealed Hinge for Half Overlay Soft-Close Doors

This Salice Series 100 hinge brings a Titanium finish to half overlay doors on face-frame and frameless cabinets, with Silentia soft-close built in and a screw-on mount that needs no special cabinet prep.

Key Features

• Silentia soft-close damps the door over the final closing arc so it settles quietly without slamming.
• Half overlay, half crank arm positions the door at a 1/2 inch overlay, including two doors sharing a single center partition.
• 105 degree opening angle delivers solid everyday access sized to the Series 100 door range.
• Screw-on mounting fastens the base plate directly to the cabinet with wood screws, no system holes required.
• Titanium finish coordinates with hardware that calls for a warm, metallic neutral tone rather than standard nickel.
• Height and side adjustment brings doors to an even reveal after installation without removing the door from the cabinet.

Half Overlay Doors on Face-Frame and Frameless Cabinets

A half overlay hinge is the right choice when a door covers the cabinet side by roughly half an inch rather than spanning it fully. That partial overlap is standard for doors that share a center partition with a neighboring door, where two half-crank arms sit back to back without collision. This hinge handles that geometry on both face-frame and frameless boxes. The 35mm cup bores into the back of the door, and the arm connects to a base plate on the cabinet, which is ordered separately. Because the mount is screw-on, the plate goes in with ordinary wood screws and no pre-drilled 5mm system holes are needed, which makes this a straightforward fit on older cabinetry and site-built boxes alike.

Titanium Build and Silentia Damping

The hinge body is titanium material in a Titanium finish, a warm metallic tone that reads as a deliberate hardware choice rather than a default. On a run of face-frame cabinets where the hinges are occasionally visible from the side, the finish carries weight. Silentia soft-close is integrated into the hinge, so no separate damper is needed to get a cushioned, quiet close. The built-in damping protects doors from repeated impact and keeps the visible reveal consistent over years of daily use. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm to minus 1.5mm let you dial in the reveal after the cabinet is set, without pulling the door.

Where This Hinge Belongs

This hinge suits renovation work, site-built cabinetry, and any project where the cabinet was not bored on the 32mm system. Contractors who want a dependable soft-close hinge without relying on pre-drilled system holes will find the screw-on plate straightforward to work with. The Titanium finish is a natural fit on jobs specifying warm-toned or bronze-adjacent hardware across pulls, knobs, and hinges. Cabinet shops building face-frame boxes for clients who want coordinated visible hardware should note the finish when quoting. For a full overlay door or an inset door on the same job, a different crank geometry is needed. For doors thicker than the standard 16 to 22mm window, a thick-door hinge is the correct call.

Common Questions

A Quiet Close With a Finish Worth Specifying

When the job calls for half overlay soft-close and the Titanium finish ties the hardware together, this hinge delivers on both counts without needing a specially prepared cabinet.