Nickel Soft-Close Hinge for Half Overlay Doors on Face-Frame and Frameless Cabinets

This Salice Series 100 Logica hinge brings Silentia soft-close to half overlay doors on both face-frame and frameless cabinets, with toolless clip mounting and a clean nickel finish.

Key Features

• Silentia soft-close damps the door through the final degrees of closing so it settles quietly without impact.
• Half overlay, half crank arm positions the door to cover roughly half the cabinet side, the geometry two adjacent doors use when sharing a center partition.
• 105 degree opening angle gives solid everyday access on this series.
• Toolless Logica mounting clips the arm to the base plate without a screwdriver for faster door hanging.
• Height and side adjustment dials in an even reveal after the cabinet is set.
• Works on face-frame and frameless cabinets when paired with the correct Salice base plate for each construction type.

Half Overlay Doors That Close Without a Sound

Half overlay is the right geometry when two doors share a single center partition, each covering about half the cabinet side, or on any partial-overlay application where the door does not reach the full edge. This hinge positions that door correctly with its half crank arm, and the Silentia soft-close takes care of the close. Rather than a spring snap, the door slows through the last few degrees and settles in place without a slam. The 35mm cup bores into the back of the door, and the hinge arm clips to a Salice base plate mounted on the cabinet. That plate is sold separately and must be a Salice plate matched to your cabinet construction and door position.

Steel Build in a Nickel Finish

The hinge is plated steel finished in nickel, a neutral, durable choice that coordinates with the full range of nickel pulls, knobs, and other cabinet hardware in a kitchen or bath. The finish holds up to the repetitive contact of daily use, and the Silentia damper keeps that daily closing load from accumulating as impact on the door and frame. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm to minus 1.5mm give enough range to true up a door after the box is installed.

Where This Hinge Belongs

This is a practical fit for cabinet shops and contractors running projects where soft-close is specified at every door and the hardware needs to read consistently in nickel. It suits remodelers working on both face-frame and frameless boxes in the same job, since the same hinge body handles both when the right Salice plate is used for each. Homeowners upgrading from spring-close to damped-close hardware will find the half overlay geometry and the Logica toolless clip make swapping doors straightforward. For standard doors in the 16 to 22mm range, this hinge fits without modification.

Common Questions

Consistent, Quiet Closes Across the Job

When the spec calls for half overlay doors with soft-close in nickel, this Salice Series 100 hinge delivers the geometry, the damping, and the finish to keep every door on the run looking and feeling the same.