Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Würth #5 x 20mm Euro Screw is a flat head, coarse-thread fastener designed for mounting European cup hinges and drawer slide hardware in 32mm system cabinetry. At 20mm in length, it reaches deeper into thicker cabinet panels and face-frame material than shorter Euro screws in the same family, making it the right choice when standard 13mm or 14.5mm screws fall short of full thread engagement.
Most Euro screw installations in thin frameless cabinet panels use shorter lengths, but the 20mm screw earns its place in specific situations. Thicker cabinet sides, face-frame-overlay construction, and some Grass hinge and slide mounting plates call for more thread depth than a 13mm or 14.5mm screw provides. Driving a screw that is too short into a deep mounting plate leaves threads engaged only near the surface, reducing pull-out resistance over time. The extra thread depth in this screw distributes the clamping load further into the panel, which matters in particleboard and MDF where the substrate near the face can be compressed during initial installation.
The nickel finish blends with the chrome and satin-nickel tones common on European hinge bodies and drawer slide hardware. Inside a finished cabinet, visible fastener heads that clash with the hardware finish stand out more than most customers expect. The 7.5mm flat head is sized to seat fully within standard hinge and slide mounting plate countersinks, sitting flush rather than proud of the plate surface. That flush seating keeps the mounting plate tight against the panel face without any rocking caused by a partially seated head.
Cabinet shops running Grass hinges and drawer slides on 32mm system casework will reach for this screw when thicker panel stock or specific hardware specs call for added length. Kitchen and bath installers fitting upper cabinet boxes with face frames benefit from the same depth advantage when driving into composite panel material where a pilot hole was bored to the hardware manufacturer's spec. The 100-piece box suits a typical job lot without excess inventory accumulating on the shelf.
The 20mm length is suited for thicker cabinet panels, face-frame-overlay construction, or Grass hardware mounting plates that require more thread engagement than 13mm or 14.5mm screws provide. When the mounting plate is deep or the panel is thick, additional thread length improves pull-out resistance in particleboard and MDF.
This screw is specified for use with Grass cabinet hardware. It is also compatible with standard 32mm system line-bored cabinets that accept a #5 Euro screw.
Yes. A Pozidriv bit has four additional ribs between the main arms that engage the matching recesses in the screw head. Using a Phillips bit in a Pozidriv recess will slip and risk stripping the head, especially under power-tool torque. Use a #2 Pozidriv bit for best results.
Yes. The 7.5mm flat head is sized to fit within the countersunk holes of standard European hinge and drawer slide mounting plates, seating flush so the plate sits tight against the panel face.
The coarse thread is optimized for particleboard, MDF, and melamine-faced panels typical of 32mm system cabinetry. In solid wood, a fine-thread screw generally provides better holding power, so confirm the substrate before specifying this screw for solid-wood cabinet sides.
When the hardware spec or panel thickness calls for more than a short Euro screw can deliver, this 20mm Würth Euro Screw covers the gap with a properly sized, nickel-finished fastener built for Grass hardware and 32mm system cabinetry.
Sold In: 100 Each