8' Aluminum Extruded By-passing Double Track 7002

8' Aluminum Double Track For Sliding Doors

8' aluminum double track gives you a full eight-foot length of sliding door hardware in one continuous run, which supports long bypass door openings without splicing separate pieces. The aluminum extruded design creates a uniform track profile along the full length, which helps sliding door carriers roll smoothly from end to end. This product is identified as Hettich America Corporation part 50529, so it lines up with projects calling for the Hettich 7002 double track system. As double aluminum carrier tracks, it provides two parallel running channels, which lets one door pass in front of another in a bypass layout. Holes at every 11 inches are built into the track, which gives a regular fastening pattern that spreads loads along the header or mounting surface.

Sliding Door Track Details That Support Work

• The double aluminum carrier tracks provide two running channels, which lets installers set up bypassing doors where one panel travels in front of another for space-saving openings.
• The 8' length delivers a continuous aluminum extruded track, which reduces joint points and helps rolling carriers travel smoothly across wider door spans in closets or room dividers.
• Holes at every 11 inches are pre-formed along the track, which creates a repeatable fastening layout that helps distribute load and maintain straight alignment during fastening.
• The track is specified as sliding door hardware in the builders hardware category, which aligns it with typical overhead sliding door and bypass cabinet applications in woodworking projects.

Mounting Pattern And Fastener Guidance

The aluminum extruded track uses holes spaced at every 11 inches along its length, which gives a clear layout for placing fasteners into a header or support. The recommended fasteners are #8 x 1-1/4" panhead screws, which match the hole pattern and allow installers to use a known screw size when securing the track. As sliding door hardware, this pattern simplifies lining up the track on wood framing or other structural members, because the spacing is predictable from end to end. The double aluminum carrier tracks use this consistent fastening approach to support bypass door loads over the full 8-foot run.

Using Double Aluminum Carrier Tracks On Projects

Where This Sliding Door Track Is Applied

This double aluminum carrier track is classified as sliding door hardware in the builders hardware category, which places it squarely in overhead sliding and bypass door work on woodworking jobs. The double track layout supports applications where two doors share the same opening, such as closet fronts or room dividers, with one door moving on each aluminum channel. At 8 feet long, it is suited to wider openings that benefit from a single continuous track rather than multiple shorter pieces. The Hettich America Corporation identity and part number 50529 connect it to the Hettich 7002 system, which matters when projects call out that specific sliding track series.

Why This Track Layout Supports Consistent Results

The aluminum extruded construction provides a uniform profile along the full 8-foot length, which helps sliding carriers move consistently and reduces variations that can affect door travel. Because the holes are set at every 11 inches, installers get a repeatable fastening pattern that helps keep the track straight and reduces the chance of localized stress points. The double aluminum carrier tracks allow doors to bypass each other on separate channels, which supports layouts where door panels need to overlap cleanly while staying on their own track. As sliding door hardware from Hettich America Corporation, this track gives woodworking professionals a defined pattern of length, hole spacing, and double-channel configuration that can be planned into production or site-built work.

Common Questions About This Sliding Door Track

Choose This Track For Bypassing Door Runs

The 8' aluminum extruded by-passing double track 7002 from Hettich America Corporation combines double aluminum carrier tracks, 8-foot length, and 11-inch hole spacing into one defined sliding door hardware component. The recommended #8 x 1-1/4" panhead screws align with the hole layout, which supports straightforward fastening into structural members. For projects that need a bypass layout with two doors on separate channels, this Hettich part 50529 track offers a clear specification you can align with your sliding door design.