Kitchen Kompact Warmwood replacement door gives you a 14 inch wide by 33 inch high recessed panel front for matching or updating existing Kitchen Kompact cabinets. The Warmwood WW33X14 door identity keeps sizing straightforward when swapping damaged fronts or standardizing across a run. The solid wood construction described in the Kitchen Kompact line supports a consistent cabinet appearance when doors and cases share the same material approach, which matters on visible kitchen walls and islands. The recessed panel style delivers a defined frame-and-panel look that pairs with typical Kitchen Kompact layouts, helping installers keep a uniform profile across base and wall cabinets. Using the WW33X14 part number streamlines ordering and jobsite labeling, which helps reduce mix-ups when multiple replacement doors are staged for a project.
The Kitchen Kompact WW33X14 Warmwood door dimension of 14 inches wide by 33 inches high ties directly to common Kitchen Kompact cabinet modules, which simplifies planning when aligning door sizes to existing cases. The recessed panel profile lets installers match other Warmwood fronts, so banks of doors present a continuous look even when only one or two fronts need replacement. Because the frame is solid 3/4 inch oak, maple or beech, hinge boring and edge work engage full-depth solid stock, giving hardware a firm bite and supporting long-term alignment. The solid wood hanging strips and 3 ply end panel cabinet structure described for the line back up that door geometry, helping the assembly resist twist so installed doors meet evenly at the center.
The WW33X14 Warmwood door works in cabinet runs that follow Kitchen Kompact sizing, so a 14 inch wide by 33 inch high opening can receive a direct replacement without redesigning the case. In a Warmwood kitchen where the cabinet frames use solid 3/4 inch oak, maple or beech and 3 ply end panels with engineered wood core and hardwood veneers, this door maintains the same material story at the front. That alignment between door and case construction helps installers deliver a finished wall or base run where grain, edge mass, and joint style stay consistent across the room. When a single front is damaged on a bank of cabinets, using the WW33X14 dimension and Kitchen Kompact identity allows the new door to visually blend with adjacent Warmwood units.
In full kitchen refresh work where cabinets remain but fronts change, the recessed panel style gives a defined frame that works cleanly against the solid wood hanging strips and solid wood toe kicks used in Kitchen Kompact cabinets. The solid frame pairs with mortise and tenon rail construction present elsewhere in the system, supporting consistent reveal lines after hinges are set. With solid wood corner blocks reinforcing the cabinet body, the WW33X14 door operates on a box built for load, so door gaps are less likely to telegraph minor box movement. Across wall and base cabinets using the same construction details, repeating this 14 by 33 Warmwood door keeps proportions aligned from one cabinet to the next.
The solid 3/4 inch oak, maple or beech frame on the Kitchen Kompact WW33X14 door handles typical machining for hinge cups and edge adjustments without breaking into voids, giving hardware a predictable seat during installation. Kiln-dried rails joined by mortise and tenon and glued for strength resist seasonal joint movement, which matters when tight gaps between pairs of doors must remain even over years of service. Solid wood corner blocks that are glued and power nailed hold the cabinet structure steady behind the door, so installers can set the WW33X14 to consistent reveals without fighting a flexing box. Solid wood hanging strips located at both top and bottom of wall and base cabinets give a firm anchor line, helping the cabinet stay square so the door closes reliably to the face.
The 3 ply end panel construction with a 1/2 inch thick engineered wood core and hardwood veneers stabilizes cabinet sides next to the door opening, limiting sidewall movement that could otherwise shift hinges out of alignment. The Warmwood recessed panel style concentrates structure in the surrounding frame, allowing the center panel to carry the visual design while the rails and stiles take hinge and catch loads. Using the WW33X14 part number on plans and pull sheets standardizes that specification across trades, reducing sizing errors when multiple openings share the same Warmwood door dimension.
The Kitchen Kompact WW33X14 Warmwood door is identified as 33 inches by 14 inches, giving installers a defined height and width to match with cabinet openings in Kitchen Kompact layouts.
The Warmwood door frame is built of solid 3/4 inch oak, maple or beech, providing a solid machining surface and a substantial edge that supports hinge installation and everyday cabinet use.
The rails are kiln-dried, joined by mortise and tenon, and then glued, producing strong, square joints that help the door hold alignment so reveals stay consistent across cabinet fronts.
Solid wood hanging strips on wall and base cabinets, located at top and bottom, stabilize the cabinet on the wall so the WW33X14 door can be aligned accurately to the face frame.
End panels use 3 ply construction with a 1/2 inch engineered wood core and hardwood veneers, helping cabinet sides stay true so hinges for the Warmwood door remain properly positioned.
Solid wood corner blocks are glued and power nailed, reinforcing cabinet corners so the structure behind the WW33X14 door resists racking when loaded, supporting smooth operation.
The Kitchen Kompact Warmwood replacement door in the WW33X14 size ties directly to Kitchen Kompact cabinet construction, from solid 3/4 inch oak, maple or beech frames to 3 ply end panels and solid wood hanging strips. That shared construction basis lets installers match existing Warmwood runs or standardize new layouts using a defined 14 inch by 33 inch recessed panel front. For jobs that call for consistent gaps, reliable hinge seating, and a unified Warmwood appearance, choosing this specific Kitchen Kompact cabinet door keeps the project tied to known dimensions and construction details from Wurth Baer Supply.
Sold In: 1 Each