Drawer Side and Slide Kit Built for Taller Storage Drawers

The Grass Zargen drawer side and slide kit combines a 3-3/8 inch tall steel side profile with an integrated runner into a single component, giving a 17-3/8 inch nominal-length drawer a finished White Epoxy interior wall and a self-closing metal slide in one unit. It is rated 100 lb per pair and suited to applications where drawer height is the primary specification driver.

Key Features

• 3-3/8 inch side height — the taller profile in the Zargen line, suited to deeper-content storage drawers where a low-profile side would leave items unsupported.
• 17-3/8 inch nominal length — the closed length of the integrated runner; fits cabinetry built around an 18 inch drawer depth.
• 3/4 extension — pulls the drawer out to roughly three-quarters of the slide length, giving good access without requiring the full cabinet depth behind the box.
• Self-closing mechanism — a ramp-based positive close pulls the drawer shut over the last inch; this is a mechanical self-close, not a damped soft-close.
• 100 lb weight capacity per pair — rated for loaded kitchen, bath, and shop drawers within a standard cabinetry build.
• White Epoxy finish on metal construction — the steel side profile carries a white epoxy coating that presents a clean interior face inside painted or white-laminate cabinet boxes.

Where a Taller Drawer Side Earns Its Place

At 3-3/8 inches, this side height is the choice for drawers holding items that a lower profile cannot reliably contain — canned goods in a pantry pull-out, boxed dry storage, cleaning supplies, or grouped small parts in a shop. A shallow side lets tall contents lean and shift; the taller Zargen profile keeps them upright and the drawer front seated correctly. The 3/4 extension means the drawer opens most of the way, which is enough access for the majority of storage tasks without the longer travel that full-extension hardware requires. If the rear of the drawer is an absolute priority, note that 3/4 extension leaves the back quarter less accessible than a full-extension configuration would.

Metal Construction, White Epoxy Finish

The Zargen side profile is formed steel, giving it a rigid wall that holds its shape under load rather than flexing the way a thin wood drawer side can. The White Epoxy coating is factory-applied and matched to the Zargen program's finish palette, so the interior of the box presents a consistent white face on both the side walls and the front-facing edge. White Epoxy suits cabinet interiors finished in white melamine or painted white — the coating reads as part of the cabinetry rather than as a contrasting hardware element. Material is metal throughout; the finish is not a paint but an epoxy coating bonded to the steel.

Right for Production Shops Running White Interiors

Cabinet shops building kitchen and bath cabinetry in white are the primary audience for this SKU. The Zargen system is designed for production environments: the side and slide arrive as one pre-assembled component, which cuts drawer-box build time compared to sourcing slides and box sides separately. Designers specifying hardware for white-interior kitchens will find the epoxy finish holds its appearance through years of drawer cycling. The 100 lb per pair rating supports typical kitchen drawer loads without oversizing the hardware. Homeowners replacing worn drawer components in an existing Zargen-equipped cabinet will want to match both the nominal length and the side height to the existing installation.

A Faster Path to a Finished White Drawer Box

Combining the side wall and the runner into one component means fewer parts to stage, fewer fasteners to drive, and a consistent white interior every time — a straightforward advantage for any shop building production cabinetry in white.