Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice Series 200 concealed hinge hangs full overlay doors on face-frame and frameless cabinets, with self-close and a 120-degree opening angle, in a nickel finish.
The 120-degree opening is the reason to choose this hinge over the standard 110-degree version. Ten degrees of extra swing makes a practical difference in tight kitchens, pantry runs, and baths where adjacent walls or appliances reduce useful clearance. The door travels farther before it runs out of arc, so the interior of the cabinet is easier to reach. Full overlay geometry keeps the look clean: the door covers the cabinet side with only a narrow edge exposed, which suits the long runs and flush lines of both modern frameless boxes and traditional face-frame builds. The 35mm cup bores into the back of the door panel, and the arm connects to a Salice base plate mounted to the cabinet. That plate is a separate purchase and must be matched to this series.
The hinge body is steel with a nickel finish. Nickel reads as a warm, mid-tone metal that pairs naturally with satin nickel pulls, knobs, and drawer slides without demanding an exact match. On face-frame cabinets where the reveal is visible, that finish continuity from hinge to other hardware keeps the interior of the box looking intentional. Screw-on mounting connects the hinge directly to the cabinet material, which is the straightforward, reliable choice when the cabinet does not have pre-drilled 5mm system holes. Side adjustment of plus 4.5mm and minus 1.5mm, combined with plus or minus 2mm of height adjustment, lets you dial in an even reveal across a run of doors after the boxes are set.
Cabinet shops and contractors running face-frame boxes will find screw-on mounting familiar and fast. Frameless builders who have not pre-bored system holes also have a clean path here, since the screw-on connection skips the INSERTA or EXPANDO tooling step. Designers specifying kitchens with limited clearance at walls or column returns will appreciate the 120-degree arc as a built-in answer to a common complaint. This hinge is for standard door panels in the 16 to 22mm thickness range. Doors thicker than 22mm need a thick-door hinge with appropriate cup geometry. For a damped, cushioned close rather than a spring pull, look to the Silentia+ soft-close version in this series.
No. The base plate mounts to the cabinet and is sold separately. It must be a Salice plate matched to your cabinet construction. Plates from other brands will not connect to this hinge.
Self-close uses a spring to pull the door shut over the last few degrees of travel. Soft-close uses a damper to slow the door so it settles without impact. This hinge is self-close: the spring draws the door closed, but there is no cushioning. For a quieter, damped close, choose the Silentia+ version of this series.
No. Screw-on mounting uses wood screws directly into the cabinet material, so there is no need for 5mm system holes. That is what makes it straightforward on both face-frame and frameless boxes that have not been line-bored.
Hinge count depends on door height and weight. As general guidance, doors up to about 40 inches tall typically use two hinges, and taller or heavier doors use three or more. Confirm the count for your specific door using the Salice load table.
Specify this hinge when a full overlay door needs a wider arc, a clean nickel finish, and a screw-on connection that works on any cabinet without special boring.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  UBS2A637XF Mfr# S2A637XF | Salice 94° Hinge Stop Device for Series 200 Hinges S2A637XF |
