Salice Series 200 Concealed Hinge in Nickel for Half Overlay Doors

This Salice Series 200 hinge brings a 120 degree opening and self-close action to half overlay doors on face-frame and frameless cabinets, with a dowel-mount cup for CNC and production environments. The nickel finish suits installs where the hinge hardware needs to coordinate with other Salice nickel components.

Key Features

• 120 degree opening angle swings the door wider than the standard 110 degree range, improving access into the cabinet.
• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• Half overlay, half crank arm positions the door to cover part of the cabinet side, the geometry used on shared partitions between two doors.
• Dowel-mount cup presses into pre-bored dowel holes for fast, repeatable installation in production runs.
• Works on face-frame and frameless cabinets when paired with the matching Salice base plate, sold separately.
• Side and height adjustment lets you dial in reveal alignment after the cabinet is assembled.

A Wider Swing for Shared-Partition Doors

The half crank arm on this hinge is built for the partial-overlay scenario: two doors meeting on a center partition, each covering about half the shared side. Where a standard 110 degree hinge gives everyday access, the 120 degree geometry opens the door noticeably farther, which matters on deeper cabinets and in tighter spaces where you want to reach in without obstruction. The 35mm cup bores into the back of the door, and the arm connects to a Salice base plate mounted on the cabinet. That plate is a separate purchase and must be a Salice plate matched to your cabinet construction; plates from other brands will not connect.

Steel Build in a Nickel Finish

The hinge body is steel finished in nickel. For shops coordinating concealed hardware across a job, specifying all Salice Series 200 components in the same nickel finish keeps the visible details consistent on any door or drawer that opens past the concealed hinge. The side adjustment range of plus 4.5mm and minus 1.5mm, combined with plus or minus 2mm of height movement, gives enough range to bring doors to an even reveal even after the cabinet is set.

Where This Hinge Belongs

This is a production-oriented hinge. The dowel-mount cup is designed for CNC workflows where cup holes and dowel holes are bored in the same setup, removing the cup-screw step from the assembly line. Cabinet shops running face-frame or frameless boxes in volume will find the dowel mount cuts assembly time per door. For smaller projects or retrofit work where the existing doors do not have pre-bored dowel holes, a screw-mount version of this series is the better fit. This hinge is for standard doors in the 16 to 22mm thickness range.

Common Questions

Wider Access, Consistent Finish, Faster Assembly

When your production workflow calls for half overlay doors with a 120 degree swing, dowel-mount speed, and nickel hardware that matches across the job, this Salice Series 200 hinge is the one to specify.