Nickel Concealed Hinge for Full Overlay Doors With a Wide Swing

This Salice Series 200 concealed hinge hangs full overlay doors on frameless or face-frame cabinets and opens to 120 degrees, giving noticeably more clearance than a standard-angle hinge. It is free-swinging with no spring or damper, and it mounts via dowel into pre-bored holes in the door.

Key Features

• 120 degree opening swings the door wider than the common 110 degree standard, opening up cabinet interiors for easier access.
• Full overlay straight arm positions the door to cover nearly the entire cabinet side, leaving only a narrow reveal.
• Free-swinging design means the door holds wherever it is pushed, with no spring pull and no damper.
• Dowel mount cup presses into pre-bored holes in the door without cup screws, suited to CNC and production setups.
• Face-frame and frameless compatible when paired with the appropriate Salice base plate, ordered separately.
• Height and side adjustment lets doors be dialed in evenly after the cabinet is in place.

More Clearance Where the Standard Angle Falls Short

A 120 degree opening makes a real difference on cabinets where a 110 degree door would crowd a countertop edge, bump into adjacent doors, or limit access to deep shelves. Kitchen base cabinets beside appliances, bathroom vanities, and pantry or utility cabinets are natural fits. The full overlay geometry covers the cabinet side so the hardware stays hidden and the face of the run looks clean.

The hinge body bores a 35mm cup into the door. The dowel mount means the cup carries pre-attached dowels that press into matching bored holes, which is the fast, consistent approach on a CNC machine or in a shop running production quantities. A Salice base plate mounts to the cabinet and the arm slides on to connect the two. That plate is sold separately; use Salice plates matched to your cabinet construction, as plates are not interchangeable across brands.

Steel Construction in a Nickel Finish

The hinge is steel with a nickel finish. Nickel reads as a warm, slightly soft silver that coordinates with brushed chrome pulls, stainless appliance hardware, and similar mid-tone metal accents without matching them exactly. Because the hinge is fully concealed when the door is closed, the finish is visible only during door travel and when a cabinet is open, but it matters for the look of an open kitchen or display cabinet. The nickel finish is consistent across the Salice Series 200 lineup, so it pairs cleanly with other Series 200 hardware specified on the same job.

Production Shops, Remodelers, and Push-to-Open Layouts

The dowel mount suits shops that bore doors on a CNC, where cup screws are an extra step the setup does not need. The free-swinging action is the right match for push-to-open handle-less fronts, where a self-closing spring would fight the opening mechanism. It also works for any layout where the door should stay open at whatever angle it is pushed to rather than pulling itself shut. For a layout that does need a door to close on its own, the self-close version of this series is the one to specify instead. Height adjusts plus or minus 2mm and side adjusts plus 4.5mm or minus 1.5mm, which is enough to bring a full run of doors to an even reveal after the boxes are set.

Common Questions

Wide Access, Clean Face, Ready for Production

Specify this hinge when the job calls for full overlay doors that open past the standard angle, mount fast in a CNC-bored door, and stay wherever they are pushed.