Nickel Half Overlay Hinge Built for 120-Degree Swing

This Salice Series 200 concealed hinge hangs half overlay doors on frameless and face-frame cabinets, with a self-close spring and a 120-degree opening angle, finished in nickel.

Key Features

• 120-degree opening angle delivers wider-than-standard swing for easier access to cabinet contents.
• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• Half overlay, half crank arm positions the door to cover roughly half the cabinet side, the geometry used where two doors share a center partition.
• Screw-on mounting fastens the hinge directly to the cabinet without clip or tool-free hardware.
• Nickel finish on steel blends with a wide range of cabinet hardware and interior metal tones.
• Height and side adjustment lets you square up doors and even out reveals after the cabinet is in place.

More Swing Where the Job Calls for It

The 120-degree opening sets this hinge apart from the standard 110-degree category. That extra swing matters in tighter spaces where a narrower opening cuts off access, and in applications where the door needs to clear a face-frame edge or an adjacent panel fully. The half crank arm positions the door at a partial overlay, covering roughly half the cabinet side. That is the geometry for partial-overlay cabinets and for pairs of doors that share a single center partition, where each door takes half the stile. The 35mm cup bores into the back of the door and the hinge body mounts to a base plate on the cabinet, which is a separate item matched to your cabinet construction and ordered separately.

Steel Build, Nickel Finish, Lasting Adjustment

The hinge body is steel with a nickel finish. Nickel reads as a warm, mid-tone metal that sits comfortably alongside satin nickel pulls, brushed hardware, and most light to medium wood tones, making it a practical default finish for projects where hardware coordination matters. Post-install adjustment gives you plus or minus 2mm of height travel and 4.5mm inward or 1.5mm outward side movement, so you can dial in an even reveal across a run of doors without removing the hinge from the cabinet.

Where This Hinge Fits the Work

Reach for this hinge on partial-overlay or double-door cabinets in kitchens, baths, and built-in casework where a 120-degree swing is specified or preferred. It mounts on both frameless boxes and face-frame cabinets, so it spans the two common construction styles in a mixed shop or on a project that uses both. The screw-on mounting suits shops that prefer a fixed, direct-screw connection over a clip-on system. For a damped, whisper-quiet close instead of a spring pull, look to the Silentia+ soft-close version of this series. For doors that sit fully over the cabinet side rather than at a partial overlay, an equivalent full-overlay hinge from the Series 200 range is the right call.

Common Questions

Half Overlay Doors That Open Wide and Close Clean

Specify this hinge when the job needs a wider swing on partial-overlay doors, a self-close spring, and a nickel finish that holds up across a full project.