Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Berenson Stylus recessed pull is a flush-mount grip for cabinet doors and drawer fronts that need hardware without visible projection, finished here in Polished Chrome on a 2-1/2 inch square footprint.
At 2-1/2 inches square, this is the largest pull in the Stylus recessed family, and it is suited to wide drawer fronts, tall cabinet doors, and furniture-scale pieces where a smaller recessed pull would look undersized. A flush pull at this dimension gives the finger enough room to seat fully inside the pocket and get a real grip, which matters on a heavier drawer or a door with some resistance. Recessed pulls are also the right call on sliding doors, appliance garages, and any application where a projecting handle would snag or interfere with adjacent cabinetry.
The pull is cast in zinc die cast and finished in Polished Chrome. Chrome at this scale reads as a clean, bright square set into the door face — a geometric accent rather than a piece of hardware standing proud of it. The polished surface reflects light evenly across the flat rim of the pocket, which sharpens the visual definition of the recess. Because the grip is recessed, fingerprints and smudges collect on the inside of the pocket rather than on an exposed bar, and the outer frame stays cleaner in daily use than a projecting pull of the same finish would.
This pull suits cabinet makers, designers, and installers specifying a handle-free or low-profile look on contemporary slab or flat-panel cabinetry. It is a practical choice for media cabinets, walk-in closet systems, and built-ins where projection conflicts with doors that need to pass each other or fold flat. At the 2-1/2 inch size it also works well on appliance garage fronts and on wider tambour or lift-up panel applications where a smaller recessed pull would require two hands or two pulls side by side. The Stylus series provides matching pieces across sizes so a consistent look can run through a full cabinet program.
This pull requires a 60 mm bore diameter routed into the door or drawer front. The routed pocket depth should accommodate the 1/2 inch (13 mm) projection of the pull body.
The outer body is square at 2-1/2 inches (64 mm) on each side. The bore opening is round at 60 mm.
The inside of the pocket sees less direct handling than the rim, so visible marks are typically limited to the outer frame. Polished surfaces wipe clean easily.
A recessed pull is well suited to sliding doors because there is nothing projecting to catch on an adjacent surface. Confirm that the door material and thickness allow for the 60 mm bore and a 1/2 inch pocket depth before routing.
Choose this pull when the application calls for a flush, projection-free grip at the 2-1/2 inch square size, in a polished chrome finish that holds a crisp edge against the door face.
Sold In: 1 Each
