Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the rear-mount, screw-on bracket for the Pro Value Series PRO 3.0 drawer slide program, designed to support the back end of a slide in face-frame cabinet installations where the cabinet side does not extend all the way to the front frame.
Face-frame cabinets set the cabinet sides back from the front stiles, which leaves the rear end of a drawer slide unsupported unless a rear bracket picks it up. This bracket closes that gap for PRO 3.0 slide installations: it anchors to the cabinet back or rear rail and holds the slide's back end at the correct height and depth. Without it, a side-mount slide in a face-frame cabinet can flex under load, causing the drawer to rack or bind. If your project uses frameless cabinets where the slide screws directly to a flat interior panel, this bracket is not needed — it is built for the face-frame case.
The bracket is steel, the same material class as the PRO 3.0 slides it supports. Steel holds its shape under the side loads and vibration that come with daily drawer use, so the bracket does not flex out of alignment over time. The screw-on design means no specialized tooling or press equipment is required for installation — a driver and the appropriate wood screws are all that is needed to secure it to the cabinet.
Cabinet shops and installers running PRO 3.0 slides into face-frame cabinetry need this bracket on every drawer where the slide cannot be fully supported by the cabinet side alone. It is also the right part for renovation work where existing face-frame boxes are being fitted with new PRO 3.0 slides and the original rear support is absent or incompatible. Order one bracket per slide end that needs rear support — the bracket is series-specific to the DSPRO3.0 program and is not a substitute for rear brackets in other Pro Value or third-party slide lines.
No. This bracket is matched to the DSPRO3.0 series. Rear brackets are engineered per series, and the geometry differs across the PRO 100, PRO560, PRO600, and PRO 3.0 programs. Use the bracket designated for whichever slide you are installing.
Not for a standard frameless installation. In a frameless cabinet the slide screws directly to the flat interior side panel, which supports the slide along its full length. This bracket is for face-frame construction, where the cabinet side is set back from the front frame and the slide's rear end would otherwise be unsupported.
One bracket per slide rear end that requires support. A standard drawer runs on two slides, so most face-frame installations call for two brackets per drawer — one on each side.
Yes — a separate PRO 3.0 rear bracket with an 8mm dowel is available for production environments where dowel mounting suits the workflow. This listing is the screw-on version.
A drawer slide is only as solid as its rear support — this bracket gives every PRO 3.0 install in face-frame cabinetry the stable anchor it needs to track cleanly from the first open to the thousandth.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  DSPRO3.0-RB-DWL Mfr# 0684075079961 168 | PRO Value DSPRO 3.0 Rear Mounting Bracket, 0684075079961 168 |
