Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Pro Value PRO 3.0 is a 22 inch full-extension side-mount ball bearing drawer slide, rated 100 lb per pair, with a bright zinc finish and standard motion — no closing mechanism, just clean, consistent travel on steel ball bearings. It ships as a complete pair.
The 22 inch length suits a typical base cabinet drawer box, and full extension means the back of the drawer comes all the way out to the cabinet opening. Standard motion keeps the mechanism simple: no self-close ramp and no soft-close damper to account for in the layout. That makes this slide a practical workhorse for kitchens, utility rooms, shop cabinets, and office casework where a clean, reliable pull is the only requirement. The non-handed format also cuts down on staging time when you are running through a job with dozens of identical drawers.
Both members are cold-formed steel with a bright zinc electroplate. Zinc is the standard protective finish for side-mount ball bearing slides in indoor cabinetry — it guards the steel against the humidity and handling of a normal kitchen or shop environment without adding bulk or changing the profile. This is not a decorative finish and is not rated for exterior or wet environments. The slide profile sits beside the drawer box, mostly out of view once the drawer is installed.
Cabinet shops building production runs, contractors outfitting new construction, and homeowners refreshing an existing cabinet lineup all land on this slide when the spec is straightforward: 22 inch depth, 100 lb capacity, full extension, zinc. It works equally well in frameless and face-frame cabinets. In a face-frame cabinet, the back end of the slide needs support from a rear mounting bracket — the bracket is series-specific and sold separately, so confirm the bracket when ordering for face-frame work. Build the drawer box 1 inch narrower than the cabinet opening to leave 1/2 inch of side clearance for each slide.
This is a complete pair — two slides arrive, one for each side of the drawer.
On a level cabinet, the drawer stays where it is left — there is no detent to hold it closed and no spring to pull it shut. If your installation is out of level or you need a stay-closed feature, look at the hold-in anti-rebound variants in this line instead.
Slide length is the closed measurement of the hardware — 22 inches in this case. Because this is a full-extension slide, the drawer travels approximately that full length, bringing the entire box out to the cabinet face. These are two separate facts; a 3/4-extension slide of the same length would only open about three-quarters of the way.
No. The PRO 3.0 is non-handed — both slides in the pair are identical and fit either side of the drawer.
Yes, with the appropriate rear mounting bracket. Face-frame construction sets the cabinet side back from the front frame, so the back of the slide needs a bracket for support. The bracket is sold separately and is series-specific — confirm the correct bracket before installing.
When the job calls for full extension and a clean zinc finish at honest capacity, the PRO 3.0 pair delivers it — the same spec, the same smooth pull, drawer after drawer.
Sold In: 10 Set
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  DSPRO3.0-RB-DWL Mfr# 0684075079961 168 | PRO Value DSPRO 3.0 Rear Mounting Bracket, 0684075079961 168 |
