Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the rear mounting bracket for the Pro 3.0 drawer slide system, engineered for production environments where an 8mm dowel press-in mount replaces hand-driving screws at every station.
Face-frame cabinets set the cabinet side back from the front frame, which means side-mount slides need rear support to bridge the gap and stay level through full travel. This bracket provides that support at the back of the slide, keeping the Pro 3.0 drawer slide aligned and stable from front to rear. It also suits frameless cabinets where the interior depth requires the slide's rear end to be anchored rather than left floating. Either way, the bracket closes the gap between a correctly running drawer and one that dips, binds, or pulls out of alignment at the back.
The distinguishing feature of this bracket is its 8mm dowel mount. Where the screw-on version of a rear bracket requires lining up and driving a fastener at every cabinet, a dowel-mount bracket drops into a pre-bored hole and seats under hand pressure — or a mallet tap. In a CNC or line-bored production shop, the holes are already there; the bracket seats once and stays. That single difference compounds across a production run. No driver, no pilot hole, no alignment repeat. The bracket is engineered to the DSPRO3.0 series, so it is not interchangeable with rear brackets from other Pro Value slide families or other brands — order specifically for the Pro 3.0 system.
Cabinet shops running the Pro 3.0 slide system through a CNC or line-bore process get the most from this bracket. The dowel mount slots into existing boring patterns without adding a fastening step, which keeps the assembly line moving. Custom builders who bore their own rear bracket holes will also find the press-in method faster than screws on repeat. This is an indoor, dry-environment accessory — it is not rated for moisture-exposed or exterior applications.
No. This bracket is specific to the Pro 3.0 (DSPRO3.0) series. Rear brackets across the Pro Value line are series-matched; a bracket from the PRO100 or PRO560 families will not align correctly on a Pro 3.0 slide.
In a standard frameless cabinet with a full-depth side panel, the slide screws directly to the side without a rear bracket. A rear bracket becomes necessary when the interior depth requires the slide's back end to land beyond the panel, or when the install calls for a floating rear mount. Check your slide's installation spec for your cabinet construction before ordering.
The bracket seats into an 8mm bored hole. Confirm bore depth with the Pro 3.0 installation documentation to ensure the dowel seats fully and the bracket sits flush.
The sold-as unit is not stated in the product data. Check the quantity shown on the product page before ordering multiple drawers to avoid a short or double order.
One bracket, one bore, one press — and the back of every Pro 3.0 drawer slide is anchored. Match the dowel mount to your existing boring pattern and skip the fastening step that slows single-piece and production installs alike.
Sold In: 1 Each
