Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is a solid maple air vent, supplied unfinished, sized to cover a 2-1/4 by 10 inch opening with a 3-3/4 by 11-3/16 inch face on the finished surface.
A 2-1/4 by 10 inch opening is one of the narrower sizes in this range, the kind that turns up along a baseboard run, at a wall register position, or in a floor where the duct spacing left less room than usual. Metal covers the opening just fine, but a wood face reads as part of the floor or wall rather than an interruption of it. That is the case this vent is built for: a narrow opening in a finished surface where the material should match what surrounds it.
The overall face is 3-3/4 by 11-3/16 inches, which is roughly three quarters of an inch wider and an inch and a quarter longer than the opening. That overlap is what keeps the vent on the surface rather than dropping into the hole. The fit dimension is the 2-1/4 by 10 inch hole size, and that is the number to confirm against the existing opening before ordering.
Maple is a close-grained, pale hardwood with minimal visible figure. It does not have the open pores or the pronounced ray pattern of red oak, which means it reads as a quieter, more uniform surface. That evenness is an advantage in a paint or clear-finish application, and it is why maple trim and maple floors tend to look calm rather than busy. Supplied unfinished, this vent can be finished in the shop or on site to match the surrounding material. It is solid wood throughout, not a veneer or a composite face.
This vent is a natural fit for any installation where a narrow opening sits inside a maple floor, maple trim package, or a surface that calls for a pale, fine-grained wood face. It also works where the finish will be painted, since maple's close grain takes primer and paint more uniformly than coarser species. Cabinet shops and finish carpenters doing complete interior packages often keep a supply on hand when the job spec includes wood registers throughout. Because the vent arrives unfinished, the finish schedule can be applied with the surrounding millwork rather than treated as a separate task.
The 2-1/4 by 10 inch hole size. The 3-3/4 by 11-3/16 inch figure is the overall face that rests on the surrounding surface.
It is solid maple and will accept the same stain, but wood varies from piece to piece, so treat it as a species match rather than a guaranteed color match. Finishing a test piece first is the safest approach.
The listing does not state whether a damper is included. Confirm before ordering if damper control is needed for the run.
Both are solid hardwoods supplied unfinished. Maple is paler and close-grained with minimal figure. Cherry is warmer-toned and darkens with light exposure over time.
Order this vent for a 2-1/4 by 10 inch opening where the face should be solid maple, unfinished and ready to match the surrounding surface.
Sold In: 1 Each
