Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is an unfinished solid maple air vent sized to cover a 3 by 10 inch opening, with a 4-1/2 by 11-3/16 inch face sitting on the finished surface around it.
Every wood vent in this range carries two dimensions, and knowing which one to use prevents an expensive mistake. The number that matters for installation is the hole size: 3 by 10 inches. That is the opening the vent is made to cover. The overall face of 4-1/2 by 11-3/16 inches is larger on purpose, overlapping the surrounding surface by roughly three quarters of an inch on each side so the vent sits over the opening rather than dropping into it. Measure the hole in the floor or wall before ordering, not the vent currently covering it, since old hardware may not reflect the actual opening.
Maple is close-grained and naturally pale, with a subdued figure that does not compete visually with the surrounding floor or trim. That restraint is part of its appeal in a vent application, where the goal is usually for the hardware to recede rather than draw attention. Because maple is a tight-grained species, it accepts stain and clear finishes evenly, giving more control over the final color than an open-grained wood would. The vent is solid maple throughout, not veneered or laminated, so the wood is consistent edge to edge and holds up to whatever finish system goes on top.
This vent is the right choice for any 3 by 10 inch opening where a wood face is preferred over metal and where maple either matches or closely coordinates with the surrounding surface. It fits naturally in maple-floored spaces, but it is also a practical option in rooms with light-toned hardwood or painted trim, since its quiet grain blends rather than contrasts. Because it arrives unfinished, the finish can be applied on-site to match the room rather than chosen from a limited factory palette. Confirm the opening dimensions before ordering.
The 3 by 10 inch hole size. That is the opening this vent covers. The 4-1/2 by 11-3/16 inch figure is the overall face that rests on the surface around the hole.
The listing does not specify whether a damper is included. Confirm before ordering if damper control is needed for the run.
It is solid maple, unfinished, so it can be stained. Wood varies piece to piece even within a species, so treat it as a species match rather than a guaranteed color match to existing flooring or trim.
The listing does not specify an orientation. Confirm the appropriate installation arrangement for your application before ordering.
Order this vent when the opening is 3 by 10 inches and the surface calls for solid maple, unfinished and ready to finish on-site.
Sold In: 1 Each
