Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is an unfinished solid red oak air vent sized to cover a 2-1/4 by 10 inch opening, presenting a 3-3/4 by 11-3/16 inch face on the finished surface.
The 2-1/4 inch width makes this one of the narrower openings in the range. That proportion suits the long, slender floor or wall registers common in older homes and in runs along baseboard walls, where the duct work is compact but the run length stretches to 10 inches. The vent's face extends roughly three quarters of an inch past the opening on each side, so the surrounding surface takes the weight and the opening stays out of sight. Measure the hole in the floor or wall before ordering, not the cover currently sitting over it.
Red oak is open-grained with a distinct, pronounced figure and a warm reddish undertone. In a floor or wall where the surrounding material is also red oak, the grain reads as part of the surface rather than an interruption of it. Supplied unfinished, the vent accepts whatever stain, oil, or clear finish is going on the surrounding wood, which is the most reliable way to close the color gap between a new cover and an existing floor or trim run. Wood varies piece to piece, so treat this as a species match rather than a guaranteed color match.
This vent is a good fit for red oak floors, red oak stair treads, or red oak millwork where a metal register face would stand out. The narrow 2-1/4 inch opening also makes it well suited to replacement projects in older construction, where compact duct sizes were common. Finish the vent before installation to keep finish off adjacent surfaces, or finish in place if the surrounding area is already coated.
The 2-1/4 by 10 inch hole size. The 3-3/4 by 11-3/16 inch figure is the overall face that rests on the finished surface around the hole.
Measure the opening itself, not the old cover. Cover sizes can vary from the original hole size if a previous replacement did not match exactly.
The listing does not state whether a damper is included. Confirm before ordering if flow control is needed.
Yes. Finishing before installation keeps stain and topcoat off surrounding surfaces and lets you coat the edges more thoroughly.
Order this vent when the opening measures 2-1/4 by 10 inches and the surrounding surface calls for red oak.
Sold In: 1 Each
