Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is an unfinished solid maple air vent built to cover a 4 by 12 inch opening, with a 5-1/2 by 13-3/16 inch face on the finished surface.
Every wood vent in this segment has two measurements, and only one of them is the fit dimension. The 4 by 12 inch hole size is what to measure against the existing opening in the floor, wall, or finished surface. The 5-1/2 by 13-3/16 inch overall size is the footprint the vent occupies once it is in place: roughly three quarters of an inch of coverage on each side, which is what keeps the vent seated over the opening rather than inside it. Get the hole size right, and the overall size takes care of itself.
Maple is dense, close-grained, and pale, with a surface that reads as calm next to the more pronounced figure of red oak or cherry. Those qualities make it a natural fit in maple flooring, maple trim, and cabinetry where a consistent, low-contrast look is the goal. Supplied unfinished, the vent takes stain, oil, or a clear protective coat after installation, so the finish can be matched to the surrounding surface in the same application. Because wood varies piece to piece, treat this as a species match rather than an exact color guarantee.
Cabinet shops finishing out a kitchen or bath, contractors wrapping up a flooring job, and homeowners replacing an existing metal or damaged wood register all reach for this vent when the surrounding surface is maple and the opening measures 4 by 12 inches. It suits any finished surface where a wood face is preferred over metal, and where the opening is already cut to the 4 by 12 inch standard. Confirm the opening dimensions before ordering.
The 4 by 12 inch hole size. That is the opening dimension. The 5-1/2 by 13-3/16 inch figure is the outer face of the vent, which overlaps the surrounding surface.
No. The vent ships unfinished, so stain, oil, or a clear topcoat can be applied to coordinate with the surrounding material.
It is solid maple, which gives you the same species. Wood grain and tone vary naturally from board to board, so it is a species match rather than a guaranteed color match.
The product listing does not state whether a damper is included. Confirm before ordering if damper control is part of your project.
This vent brings an unfinished solid maple face to a 4 by 12 inch opening, ready to be finished to match whatever surrounds it.
Sold In: 1 Each
