Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is an unfinished solid maple air vent designed to cover a 2-1/4 by 12 inch opening, presenting a 3-3/4 by 13-3/16 inch face on the finished surface.
The number to match against your existing duct or cut opening is 2-1/4 by 12 inches. That is the hole size, and it is the only figure that determines fit. The 3-3/4 by 13-3/16 inch overall face is larger on every side, sitting roughly three quarters of an inch onto the surrounding surface so the vent covers the opening rather than dropping through it. The 2-1/4 inch width is the narrower end of what this range offers, which makes it the right choice when the run is tight and a wider vent simply will not fit between joists or trim elements.
Maple is a close-grained, light-toned hardwood. Its grain is fine and relatively consistent, which gives it a calm appearance that tends to recede into a light floor or pale trim rather than drawing attention to itself. Supplied unfinished, it can be stained or sealed to coordinate with the surrounding surface after installation. Because wood varies piece to piece even within a species, treat this as a species match rather than an exact color match to existing flooring or trim.
This vent suits any existing 2-1/4 by 12 inch air opening in a finished surface where a wood face is preferred over metal. The narrow 2-1/4 inch opening dimension makes it particularly practical where space between structural or trim elements limits the available width. Cabinet shops finishing built-ins with integrated ductwork, remodelers replacing metal registers in a maple-heavy interior, and homeowners matching an existing wood floor will all find the unfinished state useful: the final finish goes on after the vent is in place, keeping the tone consistent with the surfaces around it.
Match the 2-1/4 by 12 inch hole size to your existing opening. The 3-3/4 by 13-3/16 inch figure is the overall face that rests on the finished surface around the hole.
It is the narrowest opening dimension in this range. If your duct or floor cut is 2-1/4 inches wide, this is the size that fits. A wider vent will not cover a narrower opening correctly.
The listing does not state whether a damper is included. Confirm before ordering if damper control is needed for your application.
It is solid maple, supplied unfinished, so it can be stained or finished on-site. Wood varies by piece and batch, so plan for a species match rather than a guaranteed color match.
Order this vent when the opening measures 2-1/4 by 12 inches and the face should be solid maple, finished to suit.
Sold In: 1 Each
