Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This All American Wood Register vent is an unfinished solid maple air vent built to cover a 4 by 10 inch opening, with a 5-1/2 by 11-3/16 inch face that sits on the surrounding surface.
A 4 by 10 inch opening and a 5-1/2 by 11-3/16 inch face are two distinct measurements, and only one of them determines whether this vent fits. The opening is 4 by 10 inches, and that is the figure to measure against the hole already in the floor or wall. The overall face extends beyond that opening on every side, which is what keeps the vent from dropping through and gives it a clean overlap on the finished surface. If the existing vent you are replacing shows a different overall dimension, measure the hole itself rather than the vent sitting over it.
Maple is a dense, close-grained hardwood that takes stain and clear finishes evenly. Its pale, understated figure makes it a natural fit for maple flooring and maple millwork, and the unfinished state means the finish can be matched to the surrounding surface after installation. Because the vent sits in the middle of an installed surface, the species matters more here than it might elsewhere in a room. Wood varies naturally piece to piece, so think of this as a species match rather than a guaranteed color match to existing material.
This vent suits any existing 4 by 10 inch opening in a finished surface where a wood face is the right choice over metal or plastic. It works well in new construction where the vent and the surrounding floor or trim are being finished together, and equally well in a remodel where an existing metal register is being swapped for a wood face to match updated millwork. Confirm the opening dimensions before ordering, and confirm the installation arrangement for your surface type.
4 by 10 inches. The 5-1/2 by 11-3/16 inch measurement is the overall face that rests on the surface, not the hole size.
The overlap on each side is what holds the vent in place over the opening rather than letting it fall through. The extra inch and a half in each direction gives it a clean border on the finished surface.
It is solid maple and unfinished, so you can apply the same stain or finish you used on the floor. Wood varies naturally, so the result will be close but may not be an exact color match.
The listing does not state whether a damper is included. Confirm before ordering if damper control is needed.
Order this vent when the opening measures 4 by 10 inches and the surrounding surface calls for solid maple.
Sold In: 1 Each
