Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Hettich Quadro V6 5D is a concealed, full-extension undermount drawer slide in the 400mm nominal length, engineered for frameless cabinet construction. This right-hand slide runs on ball bearings, closes on an integrated soft-close damper, and is rated 90 lb per pair — a capable, precision-fit runner for kitchen, bath, and furniture drawers built to the Quadro V6 specification.
The 400mm nominal length suits drawer boxes built to standard European depths common in frameless production cabinetry — spice drawers, inner drawers inside a deep base pull-out, and bathroom vanity drawers are typical placements. Full extension means the back of every drawer is genuinely reachable, not just close. The integrated soft-close handles the close on its own, so there is nothing to adjust or add for damped closing behavior. This slide is designed specifically for frameless cabinet construction, where it fastens directly to the flat interior side panel. It is not configured for face-frame cabinets.
The Quadro V6 5D is steel-bodied with a zinc finish — a functional, corrosion-resistant coating suited to years of indoor service. Ball bearings run in formed steel raceways, giving the carriage the load stability and consistent feel that roller-only systems do not match under heavier drawer content. The slide stays fully concealed beneath the drawer box, so the finish is a working spec rather than a decorative one. Because this is a handed slide sold as a single right-hand member, the zinc finish on each piece is identical — left and right will match at installation.
Production cabinet shops running frameless European-style work are the natural fit here. The 5D adjustment range through the Quadro V6 locking devices is especially useful on larger runs where front alignment needs to be dialed in quickly after the drawers are hung. Designers specifying concealed, soft-close undermounts for frameless cabinetry get the full-extension travel needed to make deep drawers genuinely functional. For a homeowner tackling a custom build or replacement, the Quadro V6 5D delivers the same alignment capability and closing quality found in premium installed cabinetry — provided the drawer box is built to the Hettich Quadro V6 specification for this length and side thickness.
This is the right-hand slide only. Order the matching left-hand Quadro V6 5D 400mm slide separately — one pair per drawer.
This version is engineered for drawer sides from 1/2 inch to 5/8 inch (approximately 12 to 16mm). Build the drawer box to the Hettich Quadro V6 specification for this side thickness, including the correct width formula, bottom recess, rear notch, and locking-device drilling.
No — this SKU is configured for frameless cabinets only. If your project uses face-frame construction, look for the face-frame version of the Quadro V6 line, which accommodates the rear bracket requirement that face-frame installs need.
5D refers to five directional adjustments available through the Quadro V6 front locking devices after the drawer is installed — letting you fine-tune the front panel's position without removing the drawer. The adjustment range and specific directions are governed by the locking devices, which are sold separately and are Quadro V6-specific.
Locking devices are not confirmed as included with this slide and are typically sold as separate accessories specific to the Quadro V6 series. Verify with the product listing or request confirmation before finalizing your order to avoid a second shipment.
Match the right-hand and left-hand 400mm Quadro V6 5D slides, build the drawer box to spec, add the series locking devices, and every drawer in the run closes quietly and aligns cleanly — without the adjustments that slow down a production day.
Sold In: 10 Each