Hettich Quadro V6 5D 10-Pack 320 mm Soft-Close Full Extension 90 lb Undermount Drawer Slide, Left Hand, Zinc, 9332645

Undermount Drawer Slide For Precision-Aligned Frameless Cabinetry

The Hettich Quadro V6 5D is a 320mm left-hand undermount drawer slide built for frameless cabinets where post-install front alignment matters. It runs on ball bearings, extends fully, and closes on an integrated soft-close damper, carrying up to 90 lb per pair on drawer boxes with 1/2 to 5/8 inch sides.

Key Features

• Full extension brings the entire drawer box out to the cabinet face, so rear contents are fully reachable.
• Integrated soft-close catches the drawer near the end of travel and settles it shut without slamming.
• Ball-bearing carriage delivers smooth, consistent pull under load through years of daily cycling.
• 90 lb weight capacity per pair handles loaded kitchen, bath, and utility drawers with room to spare.
• Left-hand orientation — pairs with the matching right-hand slide to make one complete, working set.
• 2D front adjustment lets the installer fine-tune the drawer front in two directions after the box is hung.

Where This Slide Fits the Job

The Quadro V6 5D is at home in production frameless cabinetry where clean lines, concealed hardware, and reliable motion are the baseline expectation. At 320mm nominal length, it suits shallow to mid-depth drawers — spice pull-outs, small utility drawers, and bathroom vanity boxes — where a shorter slide is the right fit rather than a compromise. The full-extension travel means the back of even a compact box is accessible, which matters more in a small drawer than in a deep one. If the job calls for drawers wider than standard, note that synchronization is not built into this slide; wide drawers that need both sides to track as one require a different solution.

Construction and Finish

Steel members with a zinc finish give the slide the corrosion resistance it needs for years of indoor service. The ball-bearing mechanism is the mechanical choice for applications that prioritize smooth, precise travel under sustained load — the carriage rolls cleanly rather than depending on nylon rollers, which matters on drawers that see heavy use or carry uneven loads. Because the slide mounts concealed beneath the drawer box, the zinc finish is functional rather than decorative; what the homeowner sees is the drawer front, not the hardware.

Who Orders This Slide

Cabinet shops running frameless production lines are the core buyer: the Quadro V6 5D slots into the 32mm system installation workflow and the 2D front adjustment speeds up front alignment across a run of drawers. Designers specifying handle-less kitchens or minimal bath vanities will find the concealed runner keeps the interior view uninterrupted. Contractors sourcing replacement hardware for a frameless case can match the slide by length and side thickness without guesswork. For 3/4 inch drawer sides, this slide is not the right model — the series carries a separate version for that thickness, and the two are not interchangeable.

Accurate Hardware, Reliable Alignment

Match the left-hand slide to its right-hand counterpart, build the box to spec, and the Quadro V6 5D handles the rest — smooth travel, silent close, and a front that stays true after installation.