Hettich Quadro V6 5D 10-Pack 270 mm Soft-Close Full Extension 90 lb Undermount Drawer Slide, Left Hand, Zinc, 9332641

Zinc Ball Bearing Undermount Slide for Compact Frameless Drawers

This is the left-hand member of the Hettich Quadro V6 5D concealed undermount system in the 270mm length — a full-extension, soft-close runner on ball bearings, rated 90 lb per pair, built for frameless cabinets with 1/2 to 5/8 inch drawer sides.

Key Features

• Full extension brings the entire drawer out to the cabinet face, putting every inch of a compact 270mm box within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut without slamming.
• Ball bearing carriage delivers a smooth, precise pull through the full travel range, even under load.
• 90 lb capacity per pair handles solidly loaded small drawers with room to spare.
• 5D adjustment enables post-installation fine-tuning in five directions for accurate front alignment on production runs.
• Left-hand orientation — pairs with the right-hand member to make one complete working set.

Where the 270mm Length Fits

The 270mm nominal length targets shallow drawer applications: spice pull-outs, bathroom vanity drawers, small base cabinet drawers, and similar boxes where a longer slide will not fit the available cabinet depth. At full extension, the complete drawer box clears the cabinet opening, so even a short drawer gives unobstructed access to its contents. This is the concealed-runner choice when space is tight and a clean interior look still matters.

Construction and Finish

The Quadro V6 5D runner is built from steel with a zinc finish — a functional, corrosion-resistant coating suited to years of indoor service. Ball bearings in the carriage keep travel smooth and consistent, a step up from the nylon rollers found on economy epoxy slides. Because the slide is fully hidden beneath the drawer box, the zinc finish performs rather than decorates.

Who Should Order This Slide

Production cabinet shops running frameless casework in short drawer configurations are the primary buyer here. The 5D adjustment range speeds up front alignment when hanging multiple drawers on a run — small corrections in height, side, tilt, depth, and a fifth axis are available after the drawer is seated, without pulling the box. Designers and contractors specifying handle-less or minimalist interiors also benefit: the slide disappears beneath the box, leaving only the drawer front visible. This SKU suits drawer sides from 1/2 to 5/8 inch thick; if your shop builds with 3/4 inch sides, select the appropriate 19mm-rated version instead.

The Right Runner for a Tight Depth

When cabinet depth limits your slide length but the job still calls for soft-close performance and a fully concealed look, the 270mm Quadro V6 5D left-hand runner gives you all of it — order the right-hand member alongside it and build the box to spec.