Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Salice Series 200 concealed hinge brings a 165 degree opening arc to half overlay doors on face-frame and frameless cabinets, with a self-close spring and dowel mounting in a nickel finish.
A standard concealed hinge opens to 110 degrees, which is enough for everyday kitchen access. The 165 degree arc on this hinge takes the door almost flat alongside the cabinet, clearing the opening edge to edge. That matters in corners where a standard swing would block the interior, on cabinets next to appliances where the door needs to fold back out of the way, and on any run where reaching the back of a deep box requires the door to get fully out of the working plane. The half crank sets a partial overlay, so two doors on a shared partition clear each other at that wide arc without collision. The 35mm cup bores into the back of the door, and the arm connects to a Salice base plate fastened to the cabinet, ordered separately and matched to your cabinet type.
The hinge is plated steel in a nickel finish. Nickel sits in a practical middle ground: it reads clean and current without demanding an all-chrome environment, and it coordinates with the brushed pulls, drawer slides, and other hardware common on production cabinetry. The self-close spring handles the closure. This is not a soft-close hinge, so the door pulls shut firmly rather than settling in gently. If a damped, quiet close is the specification, the soft-close version of this series is the one to select.
The dowel mount is the detail that accelerates a production line. Instead of driving cup screws, the installer presses the cup's pre-attached dowels into the bored holes in the door and moves on. Paired with a Salice plate on the cabinet side, the arm slides onto the plate and locks without a clip mechanism. This hinge suits cabinet shops that pre-bore doors on a CNC and want a repeatable process, as well as remodelers replacing hinges in existing face-frame boxes where the 165 degree swing adds genuine utility. Because it fits both frameless and face-frame cabinets, it can run across mixed cabinet stock on the same job.
No. The hinge body mounts to the door via dowels, but it clips to a separate Salice base plate on the cabinet side. That plate is sold separately. Use a Salice plate matched to your cabinet construction and the overlay position you need.
No. This is a self-close hinge: a spring draws the door shut over the last few degrees. Soft-close dampers are not offered at this wide opening angle. If you need a cushioned close, choose a hinge in the 110 degree range with the Silentia+ soft-close option.
The door covers part of the cabinet side rather than the full side. It is the correct geometry for two doors that share a center partition, where each door overlaps about half the partition. If your door covers nearly the full cabinet side on its own, a full overlay hinge is the right pick.
No. Salice hinges connect to Salice plates. The arm engagement and plate geometry are specific to the Salice system, so a plate from another brand will not fit correctly.
When the job calls for half overlay doors that open wide, close on their own, and install fast from a pre-bored door, this hinge covers all three in a finish that works across standard production hardware.
Sold In: 1 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1 Each |  UBS2BF37XY Mfr# S2BF37XY | 110˚ Reduction Clip | ||||
Sold in: 2000 Each |  UBS2AM37XG Mfr# S2AM37XG | Series 200 Stop Device Limits Opening to about 125 Deg |
