Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the right-hand cabinet member for the Knape and Vogt 8505 series, a 24 inch over-travel, 150 lb class side-mount ball bearing file drawer slide. It is a single component sold to complete or replace one side of a working 8505 slide pair, sized for lateral file drawers and heavy storage drawers that need an extra inch of clearance past the cabinet face.
Lateral file drawers sit under countertop overhangs in most workstations, and a plain full-extension slide leaves the rear hanging folders just out of reach. The 8505's one inch of over-travel pushes the drawer past the cabinet face so the back of the file box is accessible without reaching over the counter edge. The same extra travel benefits deep utility drawers behind a face frame that consumes part of the opening depth. This is a slide for drawers where access to the back matters as much as the load rating.
The 8505 cabinet member is cold-formed steel with a zinc finish — the standard for side-mount ball bearing file slides that spend their service life beside a drawer box, out of sight but under load. Zinc plating keeps the steel protected in dry indoor environments. The 150 lb class rating puts this in a different duty tier than standard kitchen cabinet slides; it is sized for a full lateral file drawer, not a pots-and-pans drawer. This is an indoor slide — it is not rated for wet, exterior, or corrosive environments.
Cabinet shops building or replacing workstation file pedestals, office furniture manufacturers, and contractors retrofitting lateral file banks will need to source 8505 cabinet members individually when one side of a pair is damaged or when production packs call for separate left and right cabinet members. Homeowners converting a built-in to a functional file station are also a fit, as long as the cabinet interior depth accommodates the 24 inch slide length. Because the drawer width ceiling for the 8505 is 30 inches, it is well suited to standard single-pedestal and lateral file formats. Confirm the left-hand cabinet member and both drawer members are in hand before starting the installation.
You need the matching left-hand cabinet member and two 8505 drawer members — one for each side of the drawer box. Drawer members are a separate line item in the 8505 series.
The drawer travels its full length and then one additional inch past that point. The 24 inch nominal slide length is the closed measurement; at full open the drawer clears the cabinet face by approximately one inch.
No. The hold-in anti-rebound detent catches the drawer once you push it closed and prevents it from bouncing back open. It does not pull the drawer shut on its own, and it does not slow the drawer on the way in. Push the drawer closed and the detent holds it there.
Yes, but a face-frame cabinet requires rear mounting brackets to support the back end of the slide — the brackets are not included and are series-specific. Standard frameless cabinet side panels accept the slide directly on the 32mm mounting grid.
Knape and Vogt recommends a maximum drawer width of 30 inches for the 8505 over-travel series.
Ordering the exact cabinet member you need — right-hand, 24 inch, 8505 over-travel — means the file drawer installation or repair moves forward without substitutions or mismatched parts. Match the remaining components from the same 8505 series and the drawer goes together right the first time.
Sold In: 10 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 20 Each |  KV8500-92-24 Mfr# 8500-92 24 | KV 8500 20-Pair Box 24" Hold-In/Anti-Rebound Side Mount Full Extension 150 lb Ball Bearing Drawer Slide, Zinc, 8500-92 24 |
