500mm Undermount Drawer Slide for Precision Frameless Cabinetry

This is the right-hand member of Hettich's Quadro V6 concealed undermount system in the 500mm (19-11/16 inch) nominal length — a full-extension, soft-close slide running on ball bearings, rated 90 lb per pair, and engineered for frameless cabinet construction with 1/2 to 5/8 inch drawer sides.

Key Features

• Full extension brings the entire drawer box out to the cabinet face, so nothing at the back of the drawer stays hidden.
• Integrated soft-close catches the drawer near the end of travel and settles it shut quietly without a slam.
• Ball bearing carriage delivers smooth, precise travel under load across the full length of the drawer's cycle.
• 90 lb capacity per pair covers loaded kitchen, bath, and utility drawers without overspecifying for the application.
• Right-hand orientation means this is a single member — pair it with the matching left-hand slide to make one working set.
• Frameless cabinet design mounts directly to the cabinet side panel for clean, efficient installation on production runs.

Where This Slide Fits the Job

The 500mm Quadro V6 is sized for the drawer depths common in base cabinet runs — deep enough for a full pots-and-pans drawer or a wide utensil pullout, shallow enough for a standard bathroom vanity. Frameless construction is the assumed environment: the slide fastens directly to the cabinet's flat interior side, with no face frame to work around. The minimum installation depth is 20-11/16 inches, so confirm the cabinet interior is deep enough before ordering this length. Build the drawer box to Hettich's published specification for the Quadro V6 series — nominal 500mm length, correct box width, bottom recess, rear notch, and locking-device drilling. An off-spec box will not seat correctly on the runners.

Construction and Finish

Steel members with a zinc finish give the Quadro V6 the corrosion resistance needed for years of indoor service. Ball bearings run between precision-formed raceways, keeping travel smooth and consistent even as the drawer cycles through daily use under load. Because the slide is mounted beneath the drawer box and out of sight, the zinc finish serves a functional role rather than a decorative one — the runner disappears completely when the drawer is closed.

Who Orders This Configuration

Production cabinet shops running frameless lines are the primary buyer: the Quadro V6 scales well across a full kitchen's worth of drawer openings, and stocking rights and lefts in bulk lets a shop pull what each drawer position needs. Designers specifying concealed slides for modern handle-less kitchens will find the full extension and soft-close combination meets the performance expectation without stepping up to a synchronized or higher-adjustment-tier slide. Contractors sourcing for a specific frameless install can match the 500mm nominal length to the drawer depth and order accordingly.

The Right Runner for a Clean Frameless Build

Pair this right-hand slide with its left-hand mate, build the box to Hettich's spec, and the Quadro V6 delivers full-extension, soft-close performance that stays completely out of sight — the standard for modern frameless cabinetry done right.