Hettich Quadro V6 5D 10-Pack 15" Soft-Close Full Extension 90 lb Undermount Drawer Slide, Left Hand, Zinc, 9374867

5D Adjustment Undermount Slide For Precision Front Alignment

The Hettich Quadro V6 5D is a 15 inch concealed undermount drawer slide with full extension, integrated soft-close, and five-dimensional front adjustment — sold here as the left-hand member. It runs on ball bearings and handles 1/2 to 5/8 inch drawer sides in both face-frame and frameless cabinets, rated 90 lb per pair.

Key Features

• Left-hand single: this is the left-hand cabinet member — pair it with the matching right-hand slide to complete one working set.
• Five-dimensional adjustment: the Quadro V6 5D's locking device system allows the drawer front to be tuned in height, side, depth, tilt, and a fifth axis after the drawer is hung.
• Full extension: the drawer box travels out to the cabinet face so the entire interior is reachable.
• Integrated soft-close: a damper catches the drawer near the end of travel and settles it shut without slamming.
• Ball-bearing carriage: steel ball bearings in formed raceways carry the load smoothly through repeated cycles.
• 90 lb capacity per pair: sized for loaded kitchen and bath drawers.

Where the 5D Adjustment Makes a Difference

The extra adjustment range in the Quadro V6 5D is most valuable when fronts need fine-tuning after installation — gaps that need closing, fronts that sit slightly proud, or drawers that tilt just enough to catch the eye. On a high-production run, the ability to dial in each front without pulling the drawer is time saved on every box. On a custom piece, it means the installer can correct for minor case variation without shimming or refitting. The 15 inch length is the right size for smaller base cabinets, vanity drawers, and narrow accent drawers where a 18 or 21 inch slide would exceed the available cabinet depth.

Construction and Finish

The Quadro V6 5D is built from steel with a zinc finish — the standard corrosion-resistant surface for ball-bearing slides used in indoor cabinetry. The ball-bearing carriage runs between formed steel raceways, keeping travel consistent and quiet under load. Because the slide mounts beneath the drawer box, the zinc finish stays out of sight once the drawer is installed; its job is protection, not appearance.

Who This Slide Suits

Cabinet shops running frameless European production and custom builders working with face-frame construction both find the Quadro V6 5D useful — it suits both cabinet types with the correct series-specific rear mounting hardware. Shops that prioritize front-alignment precision on flush-overlay or inset work will get the most from the 5D adjustment tier. The 1/2 to 5/8 inch side-thickness range covers the dovetailed and doweled drawer boxes most common in residential cabinet production. For 3/4 inch drawer sides, a different version of the series applies; the 5/8 inch maximum here is firm.

Frequently Asked Questions

The Right Tool for Front-Alignment-Critical Work

When the gap lines have to be right and the fronts need to stay where you put them, the Quadro V6 5D's five-axis adjustment earns its place — start with the left-hand member here and add the right-hand mate to complete the pair.