Hettich Quadro V6 5D 10-Pack 15" Soft-Close Full Extension 90 lb Undermount Drawer Slide, Right Hand, Zinc, 9374898

Hettich Quadro V6 5D Undermount Slide For Maximum Front Adjustment Precision

This is the right-hand 15 inch Hettich Quadro V6 5D concealed undermount slide — a full-extension, soft-close runner rated 90 lb per pair, built for drawer boxes with 1/2 to 5/8 inch sides, and sold as a bulk single for production shops stocking lefts and rights separately.

Key Features

• 5D front adjustment gives installers five axes of fine-tuning on the drawer front after hanging, making alignment fast even on tight reveals.
• Full extension carries the entire 15 inch drawer out to the cabinet face so nothing hides at the back.
• Integrated soft-close catches the drawer near the end of travel and settles it shut without slamming.
• 90 lb capacity per pair handles loaded kitchen and bath drawers without flex or rattle.
• Ball bearing system runs in formed steel raceways for smooth, precise travel under load.
• Right-hand orientation, sold as a single member — pair with the matching left-hand slide to complete one drawer installation.

Where the 5D Adjustment Pays Off

The Quadro V6 5D is built for work where drawer-front alignment matters enough to fine-tune after the cabinet leaves the shop. Five-dimensional adjustment — height, side, depth, tilt, and a fifth axis through the locking device — means a production installer can dial in an off-square front or correct for a slightly bowed face frame without pulling the drawer and starting over. For small bathroom vanity drawers, compact base cabinets, and bathroom furniture where 15 inch drawers are common, the ability to true the front in place is a real time saver across a multi-unit run. The full-extension travel means the full 15 inch interior is accessible, which matters in a shallow drawer where every inch of usable depth counts.

Construction and Finish

The Quadro V6 5D is built from steel with a zinc finish — a functional, corrosion-resistant surface suited to indoor service. Ball bearings running in formed raceways give this slide a tighter, more consistent pull than nylon-roller systems, and the feel holds up across the load range. The soft-close mechanism is integrated into the slide body rather than added on, so there are no separate damper units to stock or replace. The zinc finish is largely hidden once the drawer is installed, so it is chosen for durability and fit rather than appearance.

Who This Slide Is For

This SKU suits cabinet shops building in volume who stock Hettich Quadro V6 5D runners as handed singles — one right-hand case and one left-hand case — and pull from each as needed. At 15 inches, it fits compact vanity drawers, bathroom furniture, and narrow base cabinet drawers in both face-frame and frameless construction. Designers and contractors specifying handle-less or tight-reveal fronts will find the 5D adjustment worthwhile; it reduces on-site correction time on multi-cabinet installations where every front needs to sit flush. For drawer sides from 1/2 inch to 5/8 inch, this is the version to use — the box must be built to Hettich's specification for the Quadro V6 series, including the correct width, bottom recess, rear notch, and locking-device drilling.

The Right Slide for Precise, Production-Ready Installs

When front alignment precision matters and the job calls for a 15 inch concealed runner, the Quadro V6 5D right-hand slide gives a production shop the adjustment range to get every front right without rework.