Nickel Concealed Hinge for 1/2 Inch Overlay Doors

This Salice Series 200 hinge is a free-swinging concealed hinge for 1/2 inch overlay doors on both face-frame and frameless cabinets, with a dowel-mount cup designed for CNC and production boring environments.

Key Features

• Free-swinging motion leaves the door where it is positioned, with no spring or damper to pull or slow it.
• 1/2 inch overlay, half crank arm positions the door to cover the cabinet side by approximately half an inch, the geometry for partial-overlay and shared-partition doors.
• 110 degree opening delivers standard everyday cabinet access.
• Dowel-mount cup presses into pre-bored dowel holes without cup screws, keeping the production line moving.
• Face-frame and frameless compatible with the matching Salice base plate, ordered separately.
• Side and height adjustment lets you dial in an even reveal after the doors are hung.

Where the Half Crank Earns Its Place

A 1/2 inch overlay door covers part of the cabinet side rather than nearly all of it, and this hinge provides the half-crank geometry that makes it work. The setup is especially common where two doors share a single center partition, each overlapping half the partition edge, so both doors hang without their arms colliding behind the panel. The 35mm cup bores into the back of the door and the arm connects to a Salice base plate mounted to the cabinet, which is a separate purchase. Plates are Salice-specific, so match them from Salice's own plate range for this series.

Nickel Steel Build for Long Production Runs

The hinge is plated steel finished in nickel, a neutral tone that blends with the hardware already specified on most jobs. The dowel cup is the detail that matters most in a production shop: the pre-mounted dowels press into the door's bored holes without any cup screws, which removes a fastening step per door and keeps cabinet throughput consistent on a CNC line. Side adjustment of plus 4.5mm and minus 1.5mm, paired with plus or minus 2mm of height adjustment, gives enough range to correct minor variation across a cabinet run without re-boring.

Production Shops and Multi-Door Runs

This hinge is at home in cabinet shops that bore on a CNC or line-bore machine and want a concealed hinge that drops straight into the door without a screwdriver. It also suits remodelers and millwork contractors hanging partial-overlay doors on either frameless boxes or face-frame cabinets, since it handles both construction types on one SKU. Because this is a free-swinging hinge with no spring or damper, the door stays at whatever angle it is left. For installations where the door should pull shut on its own, the self-close version of this series is the right pick. For a damped, quiet close, choose the Silentia+ soft-close version instead.

Common Questions

Production-Ready for Every Partial Overlay Door on the Job

Specify this hinge when the drawing calls for 1/2 inch overlay doors, the shop bores on a CNC, and the install needs to move without extra fastening steps at the cup.