Salice Series 200 Concealed Hinge for Inset Doors in Nickel

This Salice Series 200 Logica hinge mounts inset doors on frameless and face-frame cabinets, with a self-close spring and toolless arm engagement in a nickel finish.

Key Features

• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• Inset geometry with full crank arm positions the door to sit flush inside the cabinet opening with an even reveal on all sides.
• 110 degree opening delivers standard everyday swing on an inset door.
• Toolless Logica mounting clips the arm to the base plate without a screwdriver.
• Height and side adjustment allows fine-tuning of the reveal after the cabinet is installed.
• Fits both frameless and face-frame cabinets when paired with the appropriate Salice base plate.

Hanging Doors That Live Inside the Opening

An inset door sits within the cabinet opening rather than overlapping it, and every millimeter of fit shows in the reveal. This hinge is built specifically for that application: the full crank arm geometry places the door flush inside the opening, and the 35mm cup bores cleanly into the back of the door. The arm then connects to a Salice base plate mounted to the cabinet, which is ordered separately. Height adjustment of plus or minus 2mm and side adjustment of plus 4.5mm or minus 1.5mm lets you dial the reveal even after the cabinet is in place, which matters on inset work where tolerances are tighter than on overlay doors. The self-close spring draws the door shut from a few degrees open so it does not drift or hang ajar, a useful trait on a closely fitted inset door.

Steel Construction in a Nickel Finish

The hinge body is steel finished in nickel, a neutral tone that coordinates with a wide range of visible hardware without competing with it. Because the hinge disappears behind the door when closed, the finish is most relevant where the cabinet is open: inside a glass-front upper, on a furniture piece with frequently used doors, or in any setting where the interior of the cabinet is part of the visible composition. The steel construction carries the load of daily use through a spring-close cycle without loosening at the plate connection.

Who Reaches for This Hinge

Cabinet shops producing furniture-quality pieces, designers specifying flush-face cabinetry, and finish carpenters fitting inset kitchens or built-ins are the primary buyers. It suits both frameless boxes and face-frame construction, so it works across mixed job types. The Logica toolless clip makes door hanging and removal fast on a production run, while the adjustment range accommodates the fitting back-and-forth that inset work demands. This is not a hinge for overlay doors: for a door that laps over the cabinet side, an overlay hinge is the correct choice. For a damped, cushioned close rather than a spring pull, the Silentia+ soft-close version of this series is the one to specify.

Common Questions

Flush Doors That Close on Their Own

When the design calls for inset doors with a clean reveal and a self-closing spring, this Salice Series 200 hinge in nickel delivers the geometry, the adjustment range, and the fast clip-on mounting to make it happen.