Salice Series 200 Concealed Hinge in Nickel for 1/2" Overlay Doors

This Salice Series 200 self-close hinge positions doors at a 1/2 inch overlay on frameless and face-frame cabinets, using a dowel mounting method and a nickel finish that coordinates with brushed metal hardware throughout a build.

Key Features

• Self-close spring pulls the door shut automatically over the last few degrees of travel.
• 1/2 inch overlay, half crank arm sets the door to a partial overlay, including pairs of doors sharing a center partition.
• Dowel mounting presses pre-mounted dowels into bored holes in the cabinet side for a fast, consistent install.
• 110 degree opening delivers the standard swing for everyday cabinet access.
• Nickel finish on steel holds up to daily use and pairs cleanly with other brushed-metal cabinet hardware.
• Side and height adjustment dials doors to an even reveal after the cabinet is set.

Where the Half Crank Does Its Work

The half crank geometry on this hinge is built for doors that overlap the cabinet side by about half an inch rather than covering it completely. That is the spec for a shared-partition run, where two doors meet on a single center divider and each takes a half-overlay hinge so the arms do not collide. It also serves single-door partial-overlay builds where the design calls for a narrower overlap than a full-overlay hinge delivers. The 35mm cup bores into the back of the door, and the arm connects to a Salice base plate on the cabinet, sold separately. Salice plates are brand-specific, so pair this hinge with a plate from the Salice range.

Steel Build, Nickel Finish, and Practical Adjustment

The hinge body is steel with a nickel plating. Nickel reads as a warm, slightly brushed silver tone that sits well next to satin nickel pulls, bar knobs, and other brushed-metal accidentals across a kitchen or bath run. The side adjustment of plus 4.5 mm and minus 1.5 mm, combined with plus or minus 2 mm of height adjustment, gives enough range to bring a pair of doors on a shared partition to a consistent reveal without re-boring. Dowel mounting anchors the plate through pre-bored holes in the cabinet side, giving a mechanical connection that stays put across repeated open-and-close cycles.

Right Cabinet, Right Job

This hinge suits frameless and face-frame cabinets in production cabinet shops, multi-unit residential builds, and remodel work where the spec is a partial overlay. It is a practical fit for builders running consistent 1/2 inch overlay throughout a project, where having a single hinge spec across the run keeps ordering simple. Because this is a self-close hinge, the spring pulls the door shut but does not cushion the close. For projects where a damped, quiet close is the requirement, the Silentia+ soft-close version of this series is the right call. For doors thicker than about 22mm, a thick-door hinge is needed in place of this standard-cup model.

Common Questions

Consistent Overlay, Clean Finish, Every Door

When the project calls for a 1/2 inch overlay throughout and a nickel finish that coordinates across the hardware spec, this Salice Series 200 hinge keeps the install moving and the reveal even.