Nickel Concealed Hinge for 1/2 Inch Overlay Doors

This Salice Series 200 Logica hinge is a self-closing concealed hinge for 1/2 inch overlay doors on face-frame and frameless cabinets, finished in nickel for a clean, hardware-coordinated look.

Key Features

• Nickel finish coordinates with other visible hardware across the cabinet run.
• Self-close spring pulls the door shut over the last few degrees of travel without a damper.
• 1/2 inch overlay, half crank arm positions the door over a partial width of the cabinet side, the correct geometry where two doors share a center partition.
• 110 degree opening delivers standard everyday access to cabinet contents.
• Toolless Logica clip mounting attaches the hinge arm to the base plate without screwdrivers.
• Side and height adjustment lets you dial in even reveals after the cabinets are set.

The Right Hinge for Partial Overlay Layouts

A 1/2 inch overlay door covers less of the cabinet side than a full overlay door, and that geometry is intentional. It is the configuration most often seen where two doors meet on a single center partition, each one stepping back to leave room for the adjacent door. The half crank arm on this hinge is what carries that position: it offsets the door correctly so both doors on a shared partition swing clear of each other. The 35mm cup bores into the back of the door, and the arm connects to a Salice base plate mounted to the cabinet, which is a separate purchase matched to your cabinet construction and overlay requirements.

Steel Build in a Nickel Finish

The hinge body is steel, plated in a nickel finish. Nickel reads as a neutral, slightly warm tone that works naturally alongside brushed or polished nickel pulls, knobs, and drawer slides on the same job. On a run of doors where every piece of visible hardware needs to read consistently, the finish choice on the hinge matters even though the hinge itself is concealed when the door is closed. The adjustment range gives you the fine-tuning to bring doors to a level, even reveal after the boxes are installed.

Where This Hinge Fits Best

This hinge suits builders and remodelers working on face-frame or frameless cabinets that call for a partial overlay door layout. It is a practical choice for production shops running multi-unit residential projects, for contractors who want a hinge their crew installs quickly with the toolless clip, and for homeowners replacing or upgrading partial overlay doors on existing cabinet boxes. The self-close spring keeps doors from hanging open without the added cost of a soft-close damper, which makes it a strong fit for utility spaces, pantries, laundry rooms, and secondary kitchens where a cushioned close is not the priority. If the project calls for a damped, quiet close, the Salice Silentia+ soft-close version of this series is the one to specify instead.

Common Questions

Consistent Hardware, Doors That Close on Their Own

Specify this hinge when the job calls for 1/2 inch overlay doors, a nickel finish that coordinates across the run, and a self-closing action that keeps every door shut without adding soft-close cost.