Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Grass 6610 right-hand rear mounting bracket is the plastic screw-on socket that anchors the back end of a Grass drawer slide in face-frame cabinet construction. Without rear support, a slide mounted in a face-frame cabinet has nothing to bear against at the back of the cabinet side — this bracket closes that gap, holding the slide level and aligned through every drawer cycle.
Face-frame cabinets set the cabinet box back from the front frame, leaving the rear of a side-mount slide without a full bearing surface unless a rear socket is added. The 6610 bracket fills that role on the right-hand side: it mounts to the cabinet back panel and receives the rear end of the Grass drawer slide, keeping the slide parallel to the drawer travel path. Skipping this bracket in a face-frame install means the back of the slide can shift or sag under load, which shortens the life of the drawer system and creates alignment problems that are difficult to correct after the cabinet is built.
The bracket is molded in white plastic. In a white-interior cabinet — melamine, thermofoil, or painted — the bracket stays visually quiet rather than drawing attention as a dark hardware element at the back of the box. The plastic construction keeps weight low and resists the minor moisture variation typical in kitchen and bath cabinet interiors.
Production shops building face-frame cabinets with Grass slides burn through rear mounting brackets at roughly the same rate as the slides themselves — one bracket per drawer side, per cabinet. A pack of 500 supports a sustained production run without repeated small orders interrupting workflow. This bracket is also useful for service and replacement work: when a rear socket cracks or goes missing in the field, having bulk stock on hand means the repair does not wait on a reorder. Specify this bracket for right-hand positions; the left-hand version is a separate item.
The 6610 is a Grass-series rear mounting socket. Confirm compatibility with the specific Grass slide series you are installing before ordering — rear brackets are series-specific and not universally interchangeable across Grass programs.
One bracket per slide member — so a standard two-slide drawer installation needs one right-hand bracket and one left-hand bracket. The right-hand and left-hand versions are separate products; this listing covers the right-hand bracket only.
Rear mounting brackets are designed for face-frame construction, where the slide's back end needs a socket to bear against the cabinet back panel. In a frameless cabinet, the slide mounts directly to the full-depth cabinet side and the rear bracket is not needed.
Yes. The left-hand rear mounting bracket is a separate SKU. Order one of each handedness to complete the rear support for a single drawer run.
A missing rear bracket is one of the most common reasons a face-frame drawer install stalls — stocking the right-hand 6610 bracket in bulk keeps that from happening on the shop floor or at the job site.
Sold In: 500 Each
