Hettich Quadro V6 5D 20-Pack 250 mm Soft-Close Full Extension 90 lb Undermount Drawer Slide, Right Hand, Zinc, 9332640

Ball Bearing Precision And Frameless Cabinet Fit — Hettich Quadro V6 5D 250mm Right-Hand Undermount Slide

This is the right-hand member of Hettich's Quadro V6 5D concealed undermount system in the 250mm length — a full-extension, soft-close runner built on ball bearings, rated 90 lb per pair, and sized for frameless cabinetry with 1/2 to 5/8 inch drawer sides. Sold as a single right-hand slide, it pairs with the matching left-hand member to make one complete working set.

Key Features

• Full extension brings the entire 250mm drawer out to the cabinet face, giving complete access to the back of the box.
• Integrated soft-close catches the drawer near the end of travel and settles it shut quietly without slamming.
• Ball bearing carriage delivers a smooth, consistent pull under load across years of daily cycles.
• 90 lb weight capacity per pair handles loaded kitchen and bath drawers without strain.
• Right-hand orientation — order the left-hand counterpart separately to complete the pair for one drawer.
• Steel construction with zinc finish holds up through long indoor service, concealed beneath the drawer box where finish is functional.

Where the 250mm Length Earns Its Place

At 250mm, this slide is engineered for shallow drawers — spice pullouts, cutlery inserts, small utility drawers, and compact bathroom vanity boxes where a longer runner simply will not fit the cabinet depth. The full-extension travel means even a short box opens completely to the face, so nothing stays buried at the back. The ball bearing mechanism keeps that pull smooth and predictable even when the drawer carries condiments, utensils, or toiletries stacked to the top of the sides. For production shops building a run of vanity units or compact base cabinets, stocking the 250mm Quadro V6 5D alongside longer lengths covers the full range of drawer depths in a single system family.

Steel Build, Ball Bearings, and a Zinc Finish That Works Unseen

The Quadro V6 5D runs on steel ball bearings rather than nylon rollers, which keeps travel smooth under heavier loads and maintains precision over time. The zinc finish over steel provides reliable indoor corrosion resistance without adding bulk to the concealed profile. Because the slide sits entirely beneath the drawer box, the finish never shows in use — its job is protection, not appearance. The soft-close damper is integrated into the slide body, so there are no external components to snag or adjust after installation.

The Right Fit: Frameless Cabinets and 1/2 to 5/8 Inch Drawer Sides

The Quadro V6 5D is specified for frameless cabinet construction, where the slide fastens directly to the flat interior panel. It is engineered for drawer sides between 1/2 inch and 5/8 inch thick — the standard range for dovetailed and doweled production drawer boxes. The drawer box itself must be built to Hettich's published specification for this series: correct nominal length, box-width formula, bottom recess, rear notch, and drilling for the Quadro-specific front locking devices. Locking devices and rear brackets for the Quadro series are system-specific and do not interchange with other brands or Quadro versions. This slide suits shops and installers already running the Quadro V6 family who need the 250mm length to complete a drawer configuration, as well as specifiers setting up a new frameless project around Hettich's runner system.

Frequently Asked Questions

The Right Runner for Compact Frameless Drawers

When the drawer is short, the cabinet is frameless, and the installation demands a ball bearing soft-close undermount, the Quadro V6 5D in 250mm delivers exactly what the spec calls for — with the precision and quiet close that keep the finished cabinet performing the way it was built.