Hettich Quadro V6 5D 10-Pack 350 mm Soft-Close Full Extension 90 lb Undermount Drawer Slide, Right Hand, Zinc, 9332648

350mm Undermount Drawer Slide for Frameless Cabinetry With Ball Bearing Precision

This is the right-hand member of Hettich's Quadro V6 5D concealed undermount system in the 350mm length — a full-extension, soft-close runner rated 90 lb per pair, built for frameless cabinets and drawer boxes with 1/2 to 5/8 inch sides. Sold as a single right-hand slide; order the matching left-hand member to complete a working pair.

Key Features

• Full extension brings the entire drawer box out to the cabinet face, giving unobstructed access to the back of the drawer.
• Integrated soft-close catches the drawer near the end of travel and settles it shut without slamming.
• Ball bearing carriage delivers precise, smooth travel under load — a step above roller-bearing undermounts in feel and long-term consistency.
• 90 lb capacity per pair handles loaded kitchen, bath, and utility drawers without flex.
• 2D adjustment lets the installer fine-tune the drawer front in height and side position after the drawer is hung.
• Steel construction with zinc finish provides durable indoor service in a low-profile concealed package.

Where This Slide Fits

The 350mm length suits drawer boxes running in the 13 to 14 inch depth range — a common size for bathroom vanity drawers, bedroom dresser pulls, and smaller kitchen utility drawers where a full 18 inch slide would be too long. Because the Quadro V6 5D mounts only in frameless cabinets, the cabinet side must be accessible for direct screw attachment; this is not the version for face-frame construction. Build the drawer box to Hettich's published specification for the Quadro series: nominal 350mm length, correct box width, bottom recess, rear notch, and the drilling pattern for the Quadro front locking devices. An unmodified or off-spec box will not seat correctly on the slide.

Construction and Finish

The Quadro V6 5D runs on a ball bearing carriage rather than the nylon rollers common in economy undermounts. Under repeated load, ball bearings maintain more consistent travel and resist lateral play more effectively — a meaningful difference in drawers that see daily use. The steel members carry a zinc finish suited to dry indoor environments. Because the slide mounts entirely beneath the drawer box, the finish is functional rather than decorative; it stays hidden from view whether the drawer is open or closed.

Who Should Order This

Cabinet shops running European frameless production that spec Hettich hardware throughout will recognize this as the runner that anchors the Quadro system at a mid-range drawer length. Designers specifying handle-less or minimal-hardware interiors benefit from the concealed mount and the 2D post-install adjustment, which speeds front alignment across a run of identical drawers. For homeowners replacing a worn slide in an existing frameless cabinet, the 350mm length and Quadro V6 series designation are the two numbers to confirm before ordering — a Quadro V6 bracket or locking device from a different version will not interchange.

Frequently Asked Questions

The Right Runner for Precise, Concealed Travel

Match the 350mm length to your drawer box depth, confirm frameless cabinet construction, and order this right-hand member with its left-hand counterpart for a complete set — then let the ball bearing carriage and integrated soft-close do the work on every open and close.