Undermount Drawer Slide For Frameless Cabinets With Full-Extension Access

This is the right-hand member of Hettich's Quadro V6 concealed undermount system in the 580mm nominal length — a full-extension, soft-close runner built on a ball-bearing carriage and rated 90 lb per pair, engineered for frameless cabinets with 1/2 to 5/8 inch drawer sides.

Key Features

• Full extension brings the entire drawer out to the cabinet face, putting every inch of the interior within reach.
• Integrated soft-close catches the drawer near the end of travel and settles it shut silently, without a separate damper add-on.
• Ball-bearing carriage delivers smooth, consistent travel under load across years of daily use.
• 90 lb weight capacity per pair handles heavily loaded kitchen and bath drawers with margin to spare.
• Right-hand orientation — this is a single member; pair it with the matching left-hand Quadro V6 slide to complete one drawer installation.
• Zinc-finish steel construction stands up to the demands of indoor cabinet work.

Where This Slide Earns Its Place

The 580mm nominal length — approximately 22-13/16 inches closed — suits deeper base cabinet drawers: pantry-adjacent storage, wide utility drawers, and kitchen layouts where a standard 18 or 21 inch slide comes up short. With a minimum installation depth of 23-13/16 inches, the cabinet interior needs to accommodate both the slide's length and the rear clearance behind it. Full extension means the back of the drawer box reaches the cabinet face, which matters most in deep runs where rear contents are otherwise hard to access. For frameless production shops running 580mm boxes, this is a direct drop-in on the Quadro V6 system.

Construction and Finish

Steel members with a zinc finish give the Quadro V6 its corrosion resistance for long indoor service life. The ball-bearing carriage — rather than the nylon rollers found on economy epoxy slides — keeps travel smooth and precise as drawer loads increase. Because the slide mounts concealed beneath the drawer box, the zinc finish serves a functional role; it is not a decorative finish visible in normal use. The 580mm body is engineered for drawer sides between 1/2 inch and 5/8 inch (12.7 to 16mm) thick, and the box must be built to Hettich's Quadro V6 specification for this length, including the correct box width, bottom recess, rear notch, and locking-device drilling.

Who Should Order This Slide

Production cabinet shops running frameless European-style casework in deeper drawer configurations will find the 580mm Quadro V6 a reliable workhorse at this length. Installers specifying concealed slides for kitchen renovations where 18 or 21 inch lengths fall short of the box depth will also reach for this size. Designers specifying for high-use kitchens — where a 90 lb rating and damped closing are non-negotiable — can count on consistent performance across the drawer stack. This is a frameless-specific slide; face-frame cabinet work requires a different configuration with rear mounting bracket support.

The Right Slide for Deeper Drawers, Done Right

When the drawer box calls for more than a standard length and frameless construction is the spec, the right-hand Quadro V6 at 580mm pairs a ball-bearing carriage and integrated soft-close with the capacity and extension class the job demands — order the left-hand member alongside it and build the box to spec.