Nickel Concealed Hinge With a 125-Degree Swing for Full Overlay Doors

The Hettich Intermat is a full overlay concealed hinge in a nickel finish, built for self-closing doors on both face-frame and frameless cabinets, with a 125-degree opening that clears the cabinet interior more fully than a standard 110-degree swing.

Key Features

• 125-degree opening angle swings the door wider than the standard 110-degree range for improved interior access.
• Full overlay straight arm positions the door to cover nearly the entire cabinet side, leaving a narrow reveal.
• Self-close spring pulls the door shut automatically from a few degrees open.
• Dowel mount presses the cup into pre-bored dowel holes in the door for a fast, screw-free door-side installation.
• Works on face-frame and frameless cabinets when paired with the appropriate Hettich base plate, sold separately.
• Nickel finish on steel blends with other nickel hardware across a full cabinet run.

More Clearance on Every Open Door

A 125-degree opening is the right call when a standard swing falls short. Where a 110-degree hinge leaves a door partly blocking the corner of a base cabinet or a pantry pull-out, the 125-degree geometry pushes the door further back, giving a cleaner path to the full interior. The 35mm cup bores into the door and the arm connects to a Hettich base plate mounted to the cabinet side or face-frame stile, ordered separately. The dowel mount means the door side goes together without cup screws: the pre-attached dowels press into bored holes, which keeps repetitive installs moving quickly.

Steel Construction in a Nickel Finish

The hinge body is steel with a nickel finish. Nickel holds up to the regular wear of kitchen and bath cabinetry and coordinates naturally with stainless pulls, bar knobs, and other nickel-finished hardware already in a project. The self-close spring is integrated into the hinge, so no separate closer or add-on is needed to get the door pulling shut on its own. The 35mm cup depth is 11.6mm, engineered for doors in the 15 to 25mm thickness range, covering both standard-thickness cabinet doors and those running slightly thicker than the common 19mm benchmark.

Cabinet Shops, Remodelers, and Multi-Cabinet Runs

This hinge is a practical fit for cabinet shops building face-frame or frameless boxes where the design specifies full overlay doors and a wider swing. Remodelers replacing hinges on an existing run will find the dowel mount speeds up door rehang, especially across a kitchen where the boring is already done. The side adjustment of plus or minus 2mm is enough to true up doors after the cabinet is set, without pulling the plate. For projects where the full door opening matters as much as the door position at rest, and where the hardware needs to read as a consistent nickel set from end to end, this hinge carries both requirements. A matching Hettich base plate is required and sold separately; Hettich plates are not interchangeable with plates from other brands.

Common Questions

Full Access, Clean Finish, Fast Install

When a project calls for full overlay doors that open wide, close on their own, and carry a consistent nickel finish across the run, this Hettich Intermat delivers on all three without adding complexity to the install.