Nickel Concealed Hinge for Flush Inset Doors on Face-Frame and Frameless Cabinets

This Hettich Sensys hinge hangs inset doors that sit flush inside the cabinet opening, with self-close and toolless arm engagement, on both face-frame and frameless cabinets. The nickel finish coordinates cleanly with polished and satin hardware across the rest of the project.

Key Features

• Inset geometry with a full crank arm positions the door flush inside the cabinet opening with an even reveal on all sides.
• Self-close spring pulls the door shut over the last few degrees of travel so it does not hang ajar.
• 110 degree opening delivers standard everyday cabinet access on a flush-fitted inset door.
• Toolless arm engagement clips the hinge to the base plate without a screwdriver, speeding up door installation and removal.
• Nickel finish on steel suits kitchens and baths where the hardware palette runs to polished or satin tones.
• Works on face-frame and frameless cabinets when paired with the correct Hettich base plate, ordered separately.

What Inset Geometry Demands From a Hinge

An inset door sits inside the cabinet opening rather than over it, framed by a small, consistent gap on every side. That reveal is what the eye lands on, and it stays even only when the hinge is built for it. The full crank arm on this hinge carries the inset position, letting the door clear the opening squarely as it swings. The 35mm cup bores into the back of the door, and the arm connects to a Hettich base plate mounted to the cabinet. That plate is a separate purchase, matched to your cabinet construction and the base plate series in this Hettich line. Because plates are brand-specific, a plate from another manufacturer will not connect to this hinge.

The self-close spring draws the door shut from a few degrees open. This is a self-close hinge, not a soft-close hinge: it pulls the door closed rather than cushioning the final arc. For inset work on face-frame boxes, that automatic pull keeps a precisely fitted door from drifting open over time.

Finish and Build for Visible Hardware Settings

The hinge body is steel with a nickel finish. Because inset cabinetry tends to show more of the reveal than an overlay door does, finish coordination matters here in a way it may not on a fully concealed overlay install. The nickel reads as a warm, polished-satin tone that sits naturally beside brushed nickel pulls, knobs, and catches. It also holds up to the repeated contact of a door pulled or pushed against its seat, which is what an inset door gets every time it is opened and closed. Door thickness can run from 15mm to 24mm with this hinge, so it handles both standard and slightly thicker inset doors without a swap to a specialty product.

Who Reaches for This Hinge

Cabinet shops and installers fitting inset doors on frameless or face-frame boxes are the core buyers. The toolless clip speeds up multi-door installs, and the self-close gives clients a door that closes on its own without requiring a separate catch. Designers specifying nickel hardware palettes will find the finish consistent with the satin and polished tones common in transitional and traditional kitchen schemes. For a project where a cushioned, damped close is part of the spec, the Sensys soft-close version is the right path instead. And if a different finish is needed, this hinge is available in additional finishes within the same Sensys family.

Common Questions

Inset Doors That Close Cleanly and Sit Square

Specify this nickel Sensys hinge when the job calls for flush inset doors that close on their own and hold a consistent reveal, on face-frame or frameless boxes where the finish needs to match a satin or polished hardware palette.